User manual

The display shows ‘brk’ . Press [ENTER], then use [UP] and [DOWN] to select a certain behaviour
for the device in case of interrupted DMX connection. Choose ‘Hold’ if you want the device in
that case to maintain the state that corresponds to the last received DMX signal. Choose ‘Hold’
if you want the device in that case to perform an automatic run. Choose ‘Sound’ if you want
the device in that case to perform a sound-controlled automatic run. Choose ‘Sound’ if you
want the device in that case to return to its home position.
When the display shows the desired value, press [ENTER] to conrm the setting and then
[DOWN] to proceed to the next menu item. To change the menu item without making any
changes, press [MODE].
The display shows ‘dISP’ . Press [ENTER], then use [UP] and [DOWN] to select whether you want
the display to show the DMX address of the device ( ‘Addr’ ) or the DMX value for the current
channel ( ‘VALu’ ).
When the display shows the desired value, press [ENTER] to store the setting and then twice
[MODE] to return to the function selection. To change the menu item without making any
changes, press [MODE].
7.2.2 Scene menu
Press [DOWN] while ‘A001’ is ashing on the display to call up the preprogrammed scene.
Press [ENTER] twice to open the Scene menu and to change scene parameters as desired.
DMX break
Display
Operating
PicoSpot 60
27
Moving Head