User manual

Press [DOWN]. The display shows ‘Strobe’ . Press [ENTER], then use [UP] and [DOWN] to set a

value between 010 and 255 for the strobe frequency of the show. Values between 000 and 009

have no function here.

When the display shows the desired value press [ENTER] to store the setting. To change the

menu item without making any changes, press [MODE]. Press [MODE] twice to return to the

function selection.

7.3 Settings menu

In this menu you can congure the device according your liking. All previous settings are

retained even when you switch the device o and disconnect it from the mains. Press [MODE]

and conrm with [ENTER] to open the settings menu .

Press [ENTER] to call up the rst menu item . With this function, you can reset the device

to its factory default setting. All your previously adjusted settings are thereby irretrievably

erased.

If you want to enable this function use [UP] and [DOWN] to select ‘on’ and conrm with

[ENTER]. If you want to disable this function use [UP] and [DOWN] to select ‘oFF’ and conrm

with [ENTER].

Strobe

Resetting to factory defaults

Operating

PicoSpot 60

Moving Head