User manual

1. Press [Mode] or [Up] | [Down] repeatedly until the display shows ‘CLor’ . All LEDs light
with full intensity.
2. Press [Setup] to then select with [Up] | [Down] the intensity of the red colour between
‘r.000’ (o) and ‘r.255’ (full).
3. Press [Setup] to then select with [Up] | [Down] the intensity of the green colour between
‘g.000’ (o) and ‘g255’ (full).
4. Press [Setup] to then select with [Up] | [Down] the intensity of the blue colour between
‘b.000’ (o) and ‘b.255’ (full).
5. Press [Setup] to then select with [Up] | [Down] the intensity of the white colour between
‘u.000’ (o) and ‘u.255’ (full).
6. Press [Setup] to then select with [Up] | [Down] the intensity of the amber colour between
‘A.000’ (o) and ‘A.255’ (full).
7. Press [Setup] to then select with [Up] | [Down] the intensity of the UV colour between
‘P.000’ (o) and ‘P.255’ (full).
8. Press [Setup] to then adjust with [Up] | [Down] the strobe frequency from ‘FS.00’ (slow)
and ‘FS.99’ (fast).
Colour mode
Operating
SePar Hex LED RGBAW UV IR
39