User manual

A constant colour can only be activated when the unit is operating in stand-alone mode or as
master in a master / slave combination. This setting is only relevant if the device is not con‐
trolled via DMX.
1. The device shows a sound-controlled colour sequence. Press [Setup] to then perform
with [Up] | [Down] the colour setting between ‘S0.01’ and ‘S0.16’ .
2. Press [Setup] to adjust the sensitivity of the built-in microphone for sound control
between ‘SU.00’ (low) and ‘SU.31’ (high).
1. Press [Mode] or [Up] | [Down] repeatedly until the display shows ‘d---’ .
2. Press [Setup] to then select with [Up] | [Down] the desired DMX address between 1 and
512 (the display shows ‘d.001’ ‘d.512’ ). Make sure that this number matches the congu‐
ration of your DMX controller.
This setting is only relevant when the device is controlled via DMX.
3. Press [Setup] to then select with [Up] | [Down] the DMX mode (6, 8 or 10 channels).
Sound control
DMX address
Operating
LED PAR
40