Operation Manual

English11
OK:Displaysprogrammeoptions.
Text(Search):Displays“GuideSearch”menu.
(Now):Showsthecurrentprogramme.
SoftwareUpgrade
+:@=&(4>.,;,-70:1J9/492,9/@;/,?492,@?:8,?4.,77D
viatheAerial/Cablesignal.
Softwareupgradesearchviauserinterface
Simplynavigateonyourmainmenu.ChooseSettings
andselectOtherSettingsmenu.InOtherSettings
menunavigateontotheSoftwareforUpgradeitem
and press OK button to check for a new software
upgrade.
3AMsearchandupgrademode
While the TV is connected to an aerial signal. If
Automatic scanning in the Upgrade Options menu
isenabled,theTVwakesupat03:00andsearches
broadcast channels for new software upgrades. If
newsoftwareisfoundanddownloadedsuccessfully,
thenexttimetheTVpowersup,itwillhavethenew
softwareversion.
Note:IftheTVfailstocomeonaftertheupgradeunplugthe
TVfor2minutesandpluginagain.

Tvwillnotturnon
Makesurethepowercordispluggedinsecurelyto
walloutlet.Thebatteriesintheremotecontrolmay
beexhausted.PressthePowerbuttonontheTV.
Poorpicture
GHaveyouselectedthecorrectTVsystem?
GLowsignallevelcancausepicturedistortion.Please
checkantennaaccess.
 Check if you have entered the correct channel
frequencyifyouhavedonemanualtuning.
Thepicturequalitymaydegradewhentwodevices
areconnectedtotheTVatthesametime.Insuch
acase,disconnectoneofthedevices.
Nopicture
GNoPicturemeans thatyourTVisnotreceivinga
transmission.Haveyouselectedthecorrectbutton
ontheremotecontrol?Tryoncemore.Alsomake
surethecorrectinputsourcehasbeenselected.
GIstheantennaconnectedproperly?
GIstheantennacabledamaged?
GAresuitableplugsusedtoconnecttheantenna?
GIfyouareindoubt,consultyourdealer.
Nosound
GHastheTVbeensettomute?Tocancelmute,press
the“
”button,orincreasethevolumelevel.
GSound is coming from only one speaker. Is the
balance set to one extreme? See Sound Menu
section.
Remotecontroldoesnotoperate
GThe batteries may be exhausted. Replace the
batteries.
Inputsourcescannotbeselected
GIfyoucannotselectaninputsource,itispossible
thatnodeviceisconnected.ifnot
GChecktheAVcablesandconnectionsifyouhave
triedtoconnectadevice.
32FDV5714 11