Operation Manual

15
EN
OTHER SETTINGS
Some settings need to enter PIN code.
Refer to “Lock Settings” (p. 21).
Channel Settings
You can edit the channel settings.
1 Use Ż / Ź to select [CHANNEL].
[Auto Tuning]
You can scan the DTV, ATV or both channel in your
area automatically.
2 Use Ÿ / ź to select [Auto Tuning], then press
OK.
3 Use Ÿ / ź to select [Tune Type], then select
[DTV], [ATV] or both channels, using Ż / Ź.
4 Use Ÿ / ź to select [Digital Type], then select
[DVB-T] or [DVB-C], using Ż / Ź.
5 Use Ÿ / ź to select [Scan Type], then select
[Full] or [Quick], using Ż / Ź.
6 Use Ÿ / ź to select the item you want, and then
adjust the setting, using Ż / Ź.
7 Press OK to start scanning.
< For DVB-T scanning >
[ATV Manual Tuning]
For Analogue TV operation
You can search ATV channel manually in your area.
2 Use Ÿ / ź to select [ATV Manual Tuning], then
press OK.
3 Use Ÿ / ź to select [Current CH], then use Ż /
Ź to select the channel you want.
4 Use Ÿ / ź to select [Color System], then use Ż
/ Ź to select the system you want.
5 Use Ÿ / ź to select [Sound System], then use
Ż / Ź to select the system you want.
6 Use Ÿ / ź to select [Fine-Tune], then use Ż / Ź
to adjust the setting.
7 Use Ÿ / ź to select [AFC], then use Ż / Ź to
select [On] or [Off].
8 Use Ÿ / ź to select [Search], then use Ż or Ź
to start scanning.
Read this first
Before adjust each setting, press MENU to display the
menu.
To exit the menu, press MENU.
• If you set [Lock System] to [On], you have to enter the 6-
digit PIN code you set using the Number buttons.
Auto Tuning
ATV Manual Tuning
DTV Manual Tuning
Programme Edit
Signal Information
CI Information
Schedule List
CHANNEL
Move SelectReturn Exit
Auto Tuning
Quick
Auto
Symbol Rate
Auto
Frequency
Auto
Network ID
Scan Type
DVB-T
Digital Type
ATV + DTV
Tune Type
Back Start
• When scanning starts, confirmation menu will appear.
• To turn back previous page, pressing MENU button in
[Auto Tuning] menu.
• In case when not all available cable channels are found
through [Full] scanning mode, these programs can be
scanned by selecting [Quick] mode. Please note, that
[Quick] mode scanning can take additional time.
• Depending on cable TV provider specification, correct
subscription to cable signals cannot be guaranteed.
• When the scanning is completed, the lowest memorised
digital or analogue channel will be displayed.
• If you press MENU during channel scanning, this operation
will be paused, then press MENU again to exit the initial
setup.
• If you set [Lock System] to [On], you have to enter the 6-
digit PIN code you set using the Number buttons.
• If you set to [On], this unit adjust tuning to near channel
automatically.