Operation Manual

18
EN
PC Settings
You can adjust the PC screen position, size and phase.
1 Use Ż / Ź to select [SCREEN].
[Auto Adjust]
Each setting will be adjusted automatically.
2 Use Ÿ / ź to select [Auto Adjust], then press
OK.
[H-Offset] / [V-Offset] / [Size] / [Phase]
Each setting can be adjusted manually.
2 Use Ÿ / ź to select the item you want, then
adjust the settings according to your personal
preference.
[Position Reset]
2 Use Ÿ / ź to select [Position Reset], then press
OK.
Picture Adjustment
You can adjust the picture settings according to your
personal preference.
These settings are automatically stored after exiting
the picture menu.
1 Use Ż / Ź to select [PICTURE].
[Picture Mode]
Each setting will be adjusted manually.
2 Use Ÿ / ź to select [Picture Mode], then press
OK.
3 Use Ÿ / ź to select [Dynamic], [Standard],
[Mild] or [Personal], then press OK.
Before you begin
You must connect your PC to this unit and select [PC]
at [Input Source]. Refer to “Switching the Input
Source Mode” (p. 9).
[H-Offset] : horizontal picture adjustment
[V-Offset] : vertical picture adjustment
[Size] : clock adjustment
[Phase] : phase adjustment
• After press OK and appear the settings display, you can
adjust them.
SCREEN
Move SelectReturn Exit
Auto Adjust
H-Offset
V-Offset
Size
Phase
Position Reset
50
50
69
50
[Dynamic] :higher contrast
[Standard] : standard
[Mild] : lower contrast
[Personal] : manual setting
• You can change picture mode easily using PICTURE
MODE.
• Press PICTURE MODE repeatedly to select picture mode
you want. In this function, you can set also assign the
picture mode individually to each input mode.
Move SelectReturn Exit
Picture Mode
Contrast
50
Brightness 50
Colour
50
Tint
Sharpness
Backlight
Colour Temp
Noise Reduction
PICTURE
Standard
Normal
50
30
40
Middle