Operation Manual

21
EN
[Sleep Timer]
The sleep timer can be set the unit to go to the standby
mode after an incremental period of time.
2 Use Ÿ / ź to select [Sleep Timer], then press
OK.
3 Use Ÿ / ź to select the time you want, then
press OK.
[Auto Standby]
You can set the time to go into standby mode
automatically as no activity is detected after power is
turned on.
In spite of this setting, the unit goes into standby mode
automatically if there is no signal input from the
antenna terminal and no user operation for 15 minutes.
2 Use Ÿ / ź to select [Auto Standby], then press
OK.
3 Use Ÿ / ź to select the time you want, then
press OK.
[OSD Timer]
You can set the OSD displaying time during no activity
is detected after press MENU.
2 Use Ÿ / ź to select [OSD Timer], then press
OK.
3 Use Ÿ / ź to select the time you want, then
press OK.
Lock Settings
You can set following lock settings.
1 Use Ż / Ź to select [LOCK].
[Lock System]
You can set all lock settings.
If you set to [On], all lock settings work.
2 Use Ÿ / ź to select [Lock System], then press
OK to set to [On].
3 Use the Number buttons to enter the 6-digit PIN
code you set.
• You can set also SLEEP button on Remote Control, refer to
“Sleep Timer” (p. 8).
Before you change the lock settings
You must remember your own PIN code.
Every lock settings need PIN code.
• If you have not set up your PIN code, enter 111111.
• When you enter correct PIN code, you can change following
settings.
• After you move to other settings, you have to enter your PIN
code again to proceed Parental setting.
• If you set to [On], below settings need to enter PIN code
due to change the settings.
: [Auto Tuning], [ATV Manual Tuning], [DTV Manual
Tuning], [Programme Edit], [First Time Installation] and
[Reset].
Move SelectReturn Exit
Lock System
Set Password
Block Program
Key Lock
Hotel Mode
Parental Guidance
Off
Off
LOCK