Operation Manual

6
EN
INITIAL SETUP
This section will guide you through the unit's initial
setup which includes selecting a language for your on-
screen menu and auto scan, which automatically
scans and memorises viewable channels.
1 After making all the necessary connections, turn
on the unit pressing .
2 Use Ż / Ź to select the location.
3
Use Ÿ / ź to select [OSD Language] , the n select
the language you want, using Ż / Ź.
4 Use Ÿ / ź to select [Country], then select the
country you want, using Ż / Ź.
5 Press OK to enter [Auto Tuning].
6 Use Ÿ / ź to select [Tune Type], then select
[DTV], [ATV] or both channels, using Ż / Ź.
7 Use Ÿ / ź to select [Digital Type], then select
[DVB-T] or [DVB-C], using Ż / Ź.
8 Use Ÿ / ź to select [Scan Type], then select
[Full] or [Quick], using Ż / Ź.
9 Use Ÿ / ź to select the item you want, and then
adjust the setting, using Ż / Ź.
10 Press OK to start scanning.
• If you select [Retail Mode], the confirm message will
appear.
Auto Tuning
First Time Installation
Home Mode
Germany
Country
English
OSD Language
Auto Tuning
Quick
Auto
Symbol Rate
Auto
Frequency
Auto
Network ID
Scan Type
DVB-T
Digital Type
ATV + DTV
Tune Type
Back Start
• When scanning starts, confirmation menu will appear.
• To turn back previous page, pressing MENU button in
[Auto Tuning] menu.
• In case when not all available cable channels are found
through [Full] scanning mode, these programs can be
scanned by selecting [Quick] mode. Please note, that
[Quick] mode scanning can take additional time.
• Depending on cable TV provider specification, correct
subscription to cable signals cannot be guaranteed.
• When the scanning is completed, the lowest memorised
digital or analogue channel will be displayed.
• If you press MENU during channel scanning, this operation
will be paused, then press MENU again to exit the initial
setup.
• You can set the setup again. Refer to “[First Time
Installation]” (p. 25)