Operation Manual

7 EN
Channel Presetting
Tuning of broadcast channels not already preset in the VCR
can be performed in two ways.
Automatic Channel Preset
• By “AUTOMATICALLY” tuning channels and placing
them in sequential order in the VCR’s memory i.e. the first
channel found will be memorized into the VCR’s channel
position 1, the second channel found will be memorized
into the VCR’s channel position 2 and so on.
• Execution of the “Automatic” channel presetting cancels all
the preset channels. DO NOT use this feature if you intend
to use some of the pre-tuned channels. Use the “Manual”
channel presetting function to tune in the additional
channels you require.
Manual Channel Preset
• Each channel is tuned manually and individually. Follow
the steps laid out in the “Manual Channel Preset” section.
Automatic Channel Preset
You can programme the tuner to scan only the channels that
you can receive in your area.
• Use the remote control for this procedure.
1) Turn on the TV and select the TV channel to the video
channel on the TV.
2) Press
MENU.
3) Press
PLAY/K or STOP/L to select “INITIAL”, then press
F.F WD /B.
4) Press
PLAY/K or STOP/L to select “CH TUNING”, then
press
F.FW D/B.
5) Press
PLAY/K or STOP/L to select “AUTO”, then press
F.F WD /B.
• The tuner scans and memorizes all the active channels in
your area. After scanning, the tuner stops on the lowest
memorized channel.
To Select a Desired Channel
You can select a desired channel by using CHANNEL (K/L), or
directly pressing the
number buttons on the remote control.
• Enter a channel number as a two-digit number for the
quickest results. For example, to select channel 6, press 0
and
6. If you only press 6, channel 6 will be selected after a
brief delay.
• You can only select channels 1–99.
Manual Channel Preset
• Use the remote control for this procedure.
1) Press
MENU.
2) Press
PLAY/K or STOP/L to select “INITIAL”, then press
F.F WD /B.
3) Press
PLAY/K or STOP/L to select “CH TUNING”, then
press
F.FW D/B.
4) Press
PLAY/K or STOP/L to select “MANUAL”, then
press
F.FW D/B.
5) Press
PLAY/K or STOP/L to select “POSITION”, then
press
F.FW D/B.
•When a weak signal is received in Manual Tuning mode,
you can change the background to solid blue or the
static screen by pressing
TAPE COUNTER RESET.
6) Press the
number buttons, PLAY/K, or STOP/L to select
your desired position number, then press
F.FW D/B.
•You can select position number 01-99.
•If [ON] appears on the right side of “SKIP”, press
PLAY/K or STOP/L to point to “SKIP”. Then, press
F.FW D/B to select [OFF].
•If you want to remove scrambled signals, press
PLAY/K
or
STOP/L repeatedly to point to “DECODER”. Then,
press
F.FW D/B to select [ON].
INITIAL
CH TUNING
CLOCK
LANGUAGE
CH TUNING
AUTO
MANUAL
MOVE
scanning
MENU
TIMER
SET UP
INITIAL
HM457ED(EN).fm Page 7 Friday, July 1, 2011 10:06 AM