EMERSON AND THE G-CLEF LOGO ARE REGISTERED TRADEMARKS OF EMERSON RADIO CORP., PARSIPPANY, NEW JERSEY, U.S.A. Owner’s Manual INITIAL SETTING LC200EM8G LC200EM8 CONNECTION 20” Digital / Analog LCD TV INTRODUCTION TM WATCHING TV OPTIONAL SETTING TROUBLESHOOTING INFORMATION TO RECEIVE DIGITAL/ANALOG SIGNAL, YOU MUST CONNECT ANTENNA. IF YOU NEED ADDITIONAL ASSISTANCE WITH SETUP OR OPERATING AFTER READING OWNER’S MANUAL, PLEASE CALL TOLL FREE 1-800-256-2487, OR VISIT OUR WEB SITE AT http://www.
INTRODUCTION WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN THIS SYMBOL INDICATES THAT DANGEROUS VOLTAGE CONSTITUTING A RISK OF ELECTRIC SHOCK IS PRESENT WITHIN THIS UNIT. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
CONNECTION 20. REPLACEMENT PARTS - When replacement parts are required, be sure the service technician uses replacement parts specified by the manufacturer that have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock, injury to persons or other hazards. 21. SAFETY CHECK - Upon completion of any service or repairs to this TV, ask the service technician to perform routine safety checks to determine that the TV is in proper operating condition. 22.
INTRODUCTION LOCATION For safe operation and satisfactory performance of the unit, keep the following in mind when selecting a place for its installation: • Shield it from direct sunlight and keep it away from sources of intense heat. • Avoid dusty or humid places. • Avoid places with insufficient ventilation for proper heat dissipation. Do not block the ventilation holes at the top and bottom of the unit. Do not place the unit on a carpet because this will block the ventilation holes.
Contents INTRODUCTION Important Safeguards. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Supplied Accessories . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Symbols Used in this Manual . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
INTRODUCTION 5 Remote Control Function 1. 1 2 3 11 2. 12 3. 13 4. 14 4 15 5 6 7 8 5. 9 10 6. 7. 8. 9. POWER button (p11) Press to turn the unit on and off. MUTE button (p13) Press to turn the sound on and off. SLEEP button (p16) Press to activate the sleep timer. Number buttons (p13) • Press to select channels. -/ENT. button • Press to shift the minor channel from the major channel. +100 button • Press to select 100 or higher channels.
INTRODUCTION 5 Control Panel SETUP VOLUME CHANNEL INPUT 1. 2. POWER 3. top of the unit 4. 6. INITIAL SETTING 5. WATCHING TV SETUP button (p12) Press to display the main menu. VOLUME X / Y buttons (p13) Press to adjust the volume or move right(X)/left(Y) through the main menu items. CHANNEL K / L buttons (p13) Press to select channels or move up/down through the main menu items. INPUT button (p15) • Press to access connected an external device like a DVD player or VCR.
CONNECTION Cables not included. Please purchase the necessary cables at your local store. 5 Basic Connection This section describes how to connect the unit to an antenna, cable/satellite box, etc. Note: • Be sure your antenna or other device is connected properly before plugging in the power cord. [Antenna Cable Connection] When connecting the unit to an antenna or cable TV company (without cable/satellite box) Connect the RF coaxial cable on your home outlet to the antenna input jack of this unit. e.g.
INTRODUCTION Cables not included. Please purchase the necessary cables at your local store. 5 External Device Connection INITIAL SETTING component video cable (green) (blue) (red) rear of this unit VIDEO 2 COMPONENT AUDIO L R Pb Pr VIDEO 1 AUDIO R S-VIDEO VIDEO L COAXIAL Y e.g.) CONNECTION [Component Video Cable Connection] Component video connection offers better picture quality for video devices connected to the unit.
CONNECTION Cables not included. Please purchase the necessary cables at your local store. [Video Connection] Video connection offers standard picture quality for video devices connected to the unit. If you connect to the unit’s video input jack, connect RCA audio cables to the audio L/R jacks of VIDEO1. When the audio jack of the video device is monaural, connect the RCA audio cable to the audio L input jack. rear of this unit VIDEO 2 COMPONENT AUDIO L R Pb Pr VIDEO 1 AUDIO S-VIDEO VIDEO L R COAXIAL Y e.
These operations are accessible by remote control. Some may also be accessible by controls on the main unit. 5 Initial Setup Note: Before you begin: Make sure if the unit is connected to antenna or cable. 1 After making all the necessary connections, press [POWER] to turn on the unit. 2 Use [Cursor K /L] to select the on-screen language from the choices on the right side of the TV screen.
INITIAL SETTING • BACK LIGHT You can set the desired brightness mode. (Refer to “Back Light Setting” on page 21.) • COLOR TEMP. You can adjust color temperature (“NORMAL”, “WARM”, “COOL”). (Refer to “Color Temperature” on page 21.) • DTVCC In addition to the basic closed caption described on page 18, DTV has its own closed caption called DTVCC. (Refer to “DTV Closed Caption” on page 19.) 5 Auto Channel Scan If you switch wires (e.g.
INTRODUCTION WATCHING TV 5 Channel Selection 5 Volume Adjustment Select channels by pressing [CH. K/L] or [the Number buttons]. This section describes how to adjust the volume. The mute function, which turns the sound off and on, is also described. • To select the memorized channels, use [CH. K/L] or [the Number buttons]. • To select the non-memorized channels, use [the Number buttons]. CONNECTION Use [VOL. X/Y] to adjust the audio volume.
WATCHING TV 5 Switching Each Mode 5 Switching Audio Mode You can easily switch with the remote control to the DTV (ATSC) and TV (NTSC) or to access an external device when they are connected to the unit. This section describes how to switch the audio in the analog mode and how to switch the audio language in the digital mode. TV Press [INPUT] repeatedly to cycle through the input mode. While receiving an MTS broadcast, press [AUDIO ] repeatedly to cycle through the available audio channel.
INTRODUCTION 5 Screen Information You can display the currently selected channel or other information such as the audio mode on the TV screen. DTV TV In the digital mode, the detailed broadcasting information for the current channel such as program title, program guides are displayed. CONNECTION In the analog mode, the current channel number is displayed. Press [DISPLAY ] repeatedly to cycle through the available display modes. Press [DISPLAY ].
WATCHING TV 5 TV Screen Display Mode DTV 2 types of display modes can be selected in the digital mode when the broadcasting station is sending 16:9 video signal. Press [SCREEN MODE aspect ratio. ] repeatedly to switch the TV 5 Sleep Timer The sleep timer can be set to automatically turn off the unit after an incremental period of time. 1 Press [SLEEP ] to set the sleep timer. SLEEP OFF • Sleep timer display appears on the TV screen.
INTRODUCTION OPTIONAL SETTING 5 Channel Add/Delete The channel add/delete function lets you add the channel that was not added by the auto channel scan due to the reception status at the initial setting. You can also delete the unnecessary channels. 2 Use [Cursor K/L] to select “CHANNEL SETUP”, then e.g.) digital TV mode • ”ADD/DELETE(DTV)” or “ADD/DELETE” menu will disappear automatically in a few seconds. • In the digital mode (DTV), you can add or delete channels only for major channel.
OPTIONAL SETTING 5 Picture Adjustment 5 Closed Caption You can adjust brightness, contrast, color, tint and sharpness. TV You can view closed captioning (cc) for TV programs, movies and news. Closed caption refer to text of dialogue or descriptions displayed on-screen for the hearing impaired. 1 Press [SETUP] to display the main menu. 1 Press [SETUP] to display the main menu. 2 Use [Cursor K /L] to select “PICTURE”, then press 2 Use [Cursor K /L] to select “CAPTION”, then press [ENTER].
INTRODUCTION 5 DTV Closed Caption DTV In addition to the basic closed caption described on page 18, DTV has its own closed caption called DTVCC. Use this menu to change the settings for DTVCC. 2 Use [Cursor K /L] to select “DTVCC“, then press [ENTER]. e.g.) digital TV mode - TV SETUP PICTURE CHANNEL SETUP V-CHIP SETUP LANGUAGE CAPTION BACK LIGHT COLOR TEMP.
OPTIONAL SETTING 5 DTVCC Style DTV You can change the style of DTV CC such as font, color or size, etc. 1 Press [SETUP] to display the main menu. • CAPTION SIZE Closed captioning font size can be changed as below. • FONT STYLE Font style of the displayed caption can be switched as below. 2 Use [Cursor K /L] to select “DTVCC“, then press [ENTER]. e.g.) digital TV mode or - TV SETUP PICTURE CHANNEL SETUP V-CHIP SETUP LANGUAGE CAPTION BACK LIGHT COLOR TEMP.
INTRODUCTION 5 Color Temperature You can set the desired brightness mode. You can adjust color temperature of the TV screen. 1 Press [SETUP] to display the main menu. 1 Press [SETUP] to display the main menu. 2 Use [Cursor K /L] to select “BACK LIGHT”, then press 2 Use [Cursor K /L] to select “COLOR TEMP.”, then press [ENTER] repeatedly to change the setting. e.g.) digital TV mode or - TV SETUP PICTURE CHANNEL SETUP V-CHIP SETUP LANGUAGE CAPTION BACK LIGHT COLOR TEMP.
OPTIONAL SETTING 5 V-chip A. TV Rating V-chip reads the ratings for programs, then denies access to the programs which exceed the rating level you set. With this function, you can block certain programming inappropriate for children. 4 Use [Cursor K /L] to select “TV RATING”, then press 1 Press [SETUP] to display the main menu. [ENTER]. e.g.) digital TV mode - V - CHIP SETUP - 2 or Use [Cursor K /L] to select “V-CHIP SETUP“, then press [ENTER].
INTRODUCTION B. MPAA Rating MPAA Rating is the rating system created by MPAA (Motion Picture Association of America). 4 Use [Cursor K /L] to select “MPAA RATING”, then press [ENTER]. e.g.) digital TV mode - V - CHIP SETUP - or TV RATING MPAA RATING DOWNLOADABLE RATING CHANGE PASSWORD Use [Cursor K /L ] to select the desired main rating, then press [ENTER] twice to show its sub ratings.
OPTIONAL SETTING C. Change Password Although the default code “0000” is supplied with the unit, you can set your own password. 4 Use [Cursor K /L] to select “CHANGE PASSWORD”, then press [ENTER]. e.g.) digital TV mode - V - CHIP SETUP - or TV RATING MPAA RATING DOWNLOADABLE RATING CHANGE PASSWORD 5 Press [the Number buttons] on the remote control to enter the new 4-digit password. • Enter password again in “CONFIRM PASSWORD” space. NEW PASSWORD _ _ _ _ CONFIRM PASSWORD _ _ _ _ 6 Press [SETUP] to exit.
INTRODUCTION TROUBLESHOOTING 5 Troubleshooting Guide If the unit does not perform properly when operated as instructed in this owner's manual, check the following chart once before calling for service. • Check the antenna or cable connection to the main unit. • When the outside antenna is used, check the wire condition and connection. • View other TV channels. The problem might be limited to the broadcasting station. • Adjust the “COLOR” in the main menu.
TROUBLESHOOTING Symptom Remedy The entered channel number changes automatically • Many digital channels have alternate channel numbers. The unit changes the numbers automatically to the ones signifying the broadcasting stations. These are the numbers used for analog broadcasts. Remote control does not work • Check the antenna or cable connection to the main unit. • Check the batteries of the remote control. • Check if there is an obstacle between the infrared sensor window and the remote control.
INTRODUCTION INFORMATION 5 Glossary Dolby Digital Password Acronym that stands for Advanced Television Systems Committee and the name of the digital broadcasting standards. The system developed by Dolby Laboratories to compress digital sound. It offers stereo sound (2ch) or multi-channel audio. A stored 4-digit number that allows access to parental control features. Aspect Ratio The width of a TV screen relative to its height.
TM LIMITED WARRANTY FUNAI CORP. will repair this product, free of charge in the USA in the event of defect in materials or workmanship as follows: DURATION: PARTS: LABOR: FUNAI CORP. will provide parts to replace defective parts without charge for one (1) year from the date of original retail purchase. Certain parts and LCD image burn-in are excluded from this warranty. FUNAI CORP. will provide the labor without charge for a period of ninety (90) days from the date of original retail purchase.
