Operation Manual
EN
4
Supplied Accessories
• Remote Control
• Batteries (R03 / AAA, 1.5 V x 2)
• Owner's Manual
• Screw kit for attaching the base
• AC power cord
Symbols Used in this Manual
The followings are the description for the symbols used in
this manual.
If neither symbol appears, the operation is applicable to
both.
Attaching the Base
You must attach the base to the unit to have it as a table
top unit. Be sure the front and rear of the base match the
proper direction.
1 Insert the main unit into metal neck of the base.
Make sure not to put the AC power cord between
the base and the unit.
At least 2 people are required for this step.
2 Drive Phillips head screws into the 4 threaded holes
at the rear of this unit until they are tight.
To remove the base from this unit
Unscrew the Phillips head screws on step 2. After the
screws are removed, move the unit up from the base.
Be careful not to drop the unit when you remove it.
Adjusting the Swivel Angles
You can adjust the viewing angle of your TV.
Installing the Batteries
Install the batteries (R03 / AAA, 1.5 V x 2) matching the
polarity indicated inside battery compartment of the
remote control.
Remote Control
Digital TV operation
Analogue TV operation
• When attaching the base, ensure that all screws are tightly
fastened. If the base is not properly attached, it could cause the
unit to fall, resulting in injuries as well as damage to the unit.
• Make sure the table is in a stable location.
DTV
ATV
• While adjusting the swivel angle of your TV, hold the base firmly
to prevent the TV from tipping over and falling down.
Top of the unit
approx.
15°
approx.
15°
approx.
15°
approx.
15°
1
2
3
4
6
7
8
9
5
10
11
17
18
19
20
21
22
16
15
12
13
14
2.A'0HO2CIG/QPFC[,WPG#/