Operation Manual

EN
7
PC Connection
Plug In the AC Power Cord
Make sure that the AC power cord must be plugged to an
AC outlet after all the necessary connections are
completed.
Initial Setup
This section will guide you through the unit's initial setting
which includes selecting a language for your on-screen
menu and auto scan, which automatically scans and
memorises viewable channels.
1 After making all the necessary connections, turns on
the unit using the main power switch, then press .
2 Use Ÿ¬/¬ź repeatedly to select the menu language,
then press OK.
3 Use Ÿ¬/¬ź to select the location, then press OK.
4 Use Ÿ¬/¬ź repeatedly to select the country, then
press OK.
5 When below display appear, then use Ÿ¬/¬ź to
select [Scan] and press OK to start scanning.
The following signals can be displayed.
• Other formats or non-standard signals will not be displayed
correctly.
• Please use the VGA cable that has a ferrite core.
PC-INRGB
AUDIO
LINE OUT
PC-IN
AUDIO
Your TV
Your device
VGA cable with
ferrite core
Mini-plug audio cable
Format Resolution Refresh rate
VGA 640 x 480
60 Hz
SVGA 800 x 600
XGA 1,024 x 768
WXGA 1,360 x 768
WXGA+ 1,440 x 900
SXGA 1,280 x 1,024
SXGA+ 1,400 x 1,050
WSXGA+ 1,680 x 1,050
HDTV 1,920 x 1,080
Your TV
AC outlet
• Select [at Home], this unit is set to maximise the energy
efficiency for home setting and it can be adjusted through a
choice of picture and sound quality according to your
preference.
• Select [Retailstore], this unit will be set up with predefined
setting for retail displays. If you select [Retailstore], the settings
of picture and sound quality you adjusted will not be
memorised after the unit goes to the standby mode.
• When “Initial Setup” (p. 7) is completed, you cannot change the
location setting unless you restore this unit to “Factory Reset”
(p. 22) and that restarts all over again such as channel scanning.
• Scan confirmation menu will appear.
• You can also set regions at “Region” (p. 19), when you select
[Spain] or [Portugal].
• If you press MENU during channel scanning, this operation will
be paused, then press MENU again to exit the initial setup.
English
Ελληνικά
Eesti
Deutsch
Dansk
Česky
Български
Please select your language.
Select Exit
Initial Setup
Initial Setup
Language
Language
ExitSelectBack OK Exit
First, please connect antenna.
Start channel scan now?
If you skip this step, the channel
scan could be performed in Menu.
Scan
Skip
Initial Setup
Initial Setup
Auto Scan
Auto Scan
2.A'0HO2CIG/QPFC[,WPG#/