Operation Manual

THINGS TO DO FOR THE FIRST TIME

ATTACHING THE STAND

You need to attach the stand to the unit to display upright. Make sure the front and rear of the stand match the proper direction.

To remove the stand from this unit

Unscrew the Phillips pan screws indicated by “C”. Pull up

the stand in the direction of the rear of the unit. Be careful

not to drop the stand when you remove it.

Fixing the unit on the TV rack

Screw this unit on your TV rack tightly using wood screws

(not supplied) in the 2 holes at the back of the stand as shown.

Recommended screw dimension : 5.1 x 20 mm

Place the unit face down onto

the soft stuff such as a cloth on a

table. Be careful not to damage

the unit screen. At least 2 people

are required at this step.

Hang the hook under the

bottom of the main unit to the

stand’s hole (shown arrow A),

then slide down the stand in the

direction of the screen (shown

arrow B).

Make sure not to put the AC

power cord between the stand

and the unit.

Drive Phillips pan screws in

the 4 threaded holes at the

bottom of the stand with a

screwdriver tightly.

front side

screw holes

Note:

• When attaching the stand, make sure that all the screws are tightly fastened. If

the stand is not attached properly, the unit may fall down, resulting in injuries

as well as damage to the unit.

• Make sure to use the table which can support the weight and size of the unit.

• Make sure that the table is in a stable location.

Note:

When you remove this unit from your TV rack,

make sure to unscrew the wood screws.

screw holes

Rear of this unit