Operation Manual

10 EN
Using a Remote Control
Remote Control Usage Guidelines:
• Make sure that there are no obstacles
between the remote control and the
infrared sensor window on the unit.
• Remote operation may become unreliable
if strong sunlight or fluorescent light is
shining on the infrared sensor window of
the unit.
• Remote control for different devices can
interfere with each other. Avoid using
remote control for other device located
close to the unit.
• Replace the battery when you notice a fall
off in the operating range of the remote
control.
• The maximum operable ranges from the
unit are as follows.
- Line of sight: approx. 7 m
- Either side of the centre: approx. 5 m
within 30°
- Above: approx. 5 m within 15°
- Below: approx. 3 m within 30°
30˚30˚
5 m 7 m 5 m
Rotating and Folding the LCD
Screen
You can rotate and fold the LCD screen as
shown below.
1 Open the LCD screen to the vertical
position. Then slowly rotate the
screen 180 degrees in the clockwise
direction.
O
PEN
2 Push the screen down onto the
main body of the unit.
Caution
• There may be 0.01% or less chance of
missing or constantly turned on pixels
on the LCD screen. This is not a
malfunction.
• Do not place the unit with the LCD
screen side down when the screen is
open. This may scratch the surface of
the LCD screen.
• Do not rotate the screen over 180
degrees. It may cause a damage to the
unit.
• Do not insert a finger between the
screen and the main body of the unit
when rotating the screen.
Note
• To return the LCD screen to its original
position, open the screen to a vertical
position and rotate it slowly counter-
clockwise.