Operation Manual

52 EN
Easy (Wired)
Network settings are set to the following
settings initially. (In most cases, you can
connect to the Internet without making any
changes to the default settings.)
- IP Address SettingAuto(DHCP)
- DNS SettingAuto(DHCP)
- Proxy SettingDo Not Use
- Connection Speed Auto
- BD-Live SettingAllow
If you want to set the network settings back
to the default settings as above (except
“BD-
Live Setting”), follow the procedure
below.
1 In “Network Connection” menu, use
[K / L] to select “Network
Selection”, then press [OK].
2 Use [K / L] to select “Wired”, t hen
press [OK].
3 Use [K / L] to select “Easy”, then
press [OK].
• The unit will start the connection test
automatically and the test result will
appear right after the test finishes.
4 Press [OK] to activate the network
settings and set the network
connection automatically. Press
[SETUP] to exit.
Note
• The setting of “BD-Live Setting” will not
be set back to the default, even if you
follow the procedure.
Custom (Wired)
In the following cases, select “Custom”(wired)
to set each setting as necessary.
-When connection test failed wit
h the
setting of “Easy”(wired).
-When instructed by your Internet service
provider to make specific settings in
accordance with your network
environment.
To set the network setting to
“Custom”(wired), follow the procedure below.
1 Follow steps 1 to 2 in “Easy (Wired)”
on this page.
2 Use [K / L] to select “Custom”, t hen
press [OK].
-Setting menu of “Custom”(wired) will be
displayed.
3 Use [K / L] to highlight the item
you want to set.
4 Find the instruction for the item
from the following, and set the
item.
IP Address Setting / DNS Setting
1 Press [OK] repeatedly to select the
desired setting.
“Auto(DHCP)” :If your router has DHCP
server function, select
“Auto(DHCP)”.
“Manual” :If your router does not
have DHCP server
function, select “Manual”.
If you select “Manual”, follow the
instructions below to set the IP address
and DNS.
a) Use [K / L] to select “IP Address”, “Su
bnet
Mask” or “Default G ateway”, then press
[OK]. IP address setting screen will appear.
Enter IP address, subnet mask or default
gateway with cursor buttons and number
buttons.
• Enter the IP address number after
checking the specif
ications of your
router.
• If the IP address is unknown, check the
IP address of other devices. (e.g. PC
connected via LAN cable) and assign a
different number from those of other
devices.
b) After you enter all correctly, press [OK].
Conf
irmation message will appear. Select
“Yes” to complete the settings.
c) Use [K / L] to select “Primary DNS” or
“Secondary DNS”, then press [OK]. DNS
setting screen will appear. Enter primary
DNS or secondary DNS with cursor
buttons and numb
er buttons.
• Enter the DNS addresses provided by
your Internet provider.
• If the DNS address is unknown, check
the DNS address of other devices (e.g.
PC connected via LAN cable) and assign
the same DNS address.
X6500UD_OM.indb 52X6500UD_OM.indb 52 2010/11/08 16:26:512010/11/08 16:26:51