Operation Manual

35
EN
Introduction Connections Playback Editing OthersFunction SetupRecording VCR Functions
Basic Setup /
TV View Operation
The error number appears on “Timer Programming” list.
The error programme will be displayed in grey with an error
number.
The error numbers indicate:
• Timer programme with an error number will be cleared once
the entry screen for the programme is displayed.
• If there is a power failure or the unit is unplugged for more
than 30 seconds, the clock setting and all timer settings will
be lost.
• If a disc is not inserted or if a inserted disc is not recordable
(finalised DVD-RW/-R, a fully recorded disc, etc.), the unit
will perform the alternate recording to the HDD. (See
page 34.)
• When a timer recording is completed, the unit will ask you
whether to turn off the unit if there is no timer recording
which starts within 4 minutes, except under conditions listed
below.
- During playback of HDD or DVD.
- While displaying menus or information on the screen.
The unit will be turned off automatically if you select “Yes” or
if you do not reply in 1 minute.
• When the programmed starting and ending time are earlier
than the current time, the setting will not be accepted.
• The audio language which is selected in the “DVB Setting”
will be recorded for digital TV broadcasting.
• Timer recording whose recording time exceeds 12 hours
cannot be made.
• It is prohibited to turn off the unit from 4 minutes before the
programmed starting time.
• It is prohibited to change channel from 15 seconds before
the programmed starting time.
• [REC] does not work from 2 minutes before the
programmed starting time. If it comes to 2 minutes before
the starting time during regular or one-touch timer recording,
the recording in progress will be stopped.
• Playback of DVD/CD is prohibited from 2 minutes before the
programmed starting time when the recording media is DVD.
If it comes to 2 minutes before the programmed starting time
during DVD/CD playback, the playback will be stopped.
• When 2 or more programmes are overlapped, “Timer
programme overlapped” appears, and the overlapped
programme will be displayed in blue. To correct the timer
programme refer to “Checking, Cancelling or Correcting the
Timer Programming Information” on page 34.
• If the Start time is earlier and the End time is later than the
current time, the recording will start immediately after you
press [ENTER\OK] at step
10 on page 33.
• As to the timer recording in progress (which is shown in red
in the timer programme list), you only can edit the end time.
The changes made during recording will be recognised as
only specific to that recording in progress and it will not
affect the daily or the weekly recording setting.
If the Timer Programming did not
Complete Correctly
E1–E22, E37–E39 Recording error
E23–E24 Unrecordable disc
E25/E51 • Copy prohibited programme
• Cannot record because of the NTSC /
PAL-60 signal is received.
E26–E28 Copy prohibited programme
E29 Disc protected
E30 Disc full
E31 Already recorded 99 titles (video mode)
E32 Already recorded 99 titles (VR mode)
E33 Already recorded 999 chapters
E34 No space for Control Information
E35 PCA (Power Calibration Area) full
E36 Already finalised video format disc
E40 • There are some unrecorded parts due
to the overlapped timer programmes.
• Recording did not start at the start
time.
E41 Power failure
E42 No disc
E45 Copy prohibited programme
E47 Already 600 titles recorded on the HDD.
E49–E50 HDD recording is cancelled due to the
insufficiency of the disc space on the
HDD.
1/1
E40
14/05 7:00 9:00 1 TF1
14/0510:00
Date Start End CH
Timer Programming
STTL
VPS/PDC
MON
New Programme
Notes for the Timer Recording