- Funai Owner Manual Digital Video Disc Recorder ZC350MS8

9EN 9EN
Recording Playback Editing
Introduction
Connections Basic Setup Function Setup Others
Español
Note
• Do not touch the inner pins of the jacks on the rear
panel. Electrostatic discharge may cause permanent
damage to the unit.
• This unit does not have the RF modulator.
VIDEO
IN
AUDIO IN
(
E1
)
S-VIDEO S-VIDEO
ANTENNA
AUDIO OUT
COMPONENT
VIDEO OUT
DIGITAL AUDIO OUTPUT
PCM/BITSTREAM
IN OUT
COAXIAL
L
R
L
R
Y
PB/CB
PR/CR
VIDEO
OUT
IN
OUT
21
8
3 4
79 5611 10
FUNCTIONAL OVERVIEW
1. ANTENNA IN jack
Use to connect an antenna.
2. VIDEO IN jack (E1)
Use to connect external device with a RCA video
cable.
3. VIDEO OUT jack
Use to connect a TV monitor, AV receiver or other
device with a RCA video cable.
4. AC Power Cord
Connect to a standard AC outlet to supply power to
this unit.
5. COAXIAL DIGITAL AUDIO OUTPUT jack
Use to connect an AV receiver, Dolby Digital decoder
or other device with a coaxial digital input jack with a
digital coaxial cable.
6. S-VIDEO OUT jack
Use to connect the S-video input of a TV monitor, AV
receiver or other device with an S-video cable.
7. COMPONENT VIDEO OUTPUT jacks
Use to connect a TV monitor with component video
inputs with a component video cable.
8. AUDIO OUT jacks
Use to connect a TV monitor, AV receiver or other
device with a RCA audio cable.
9. S-VIDEO IN jack (E1)
Use to connect the S-video output of external device
with an S-video cable.
10. AUDIO IN jacks (E1)
Use to connect external device with a RCA audio
cable.
11. ANTENNA OUT jack
Use to connect an RF coaxial cable to pass the signal
from the ANTENNA IN to your TV.
Rear Panel
E7H51UD.indd 9E7H51UD.indd 9 2007/02/19 18:23:232007/02/19 18:23:23