Datasheet

bintec RS353jwv
04.06.2015
Subject to technical alterations
Page 6 / 13
bintec elmeg GmbH - Suedwestpark 94 - 90449 Nuremberg - Germany
Phone: +49 - 911 9673-0 - Telefax: +49 - 911 688 07 25
E-Mail: [e-mail] - www.bintec-elmeg.com
ISDN
ISDN leased lines Supported leased lines: D64S, D64S2, TS02, D64S2Y
ISDN auto-configuration Automatic recognition and configuration of ISDN protocols
CAPI CAPI 2.0 with CAPI user concept (password for CAPI use)
Bit rate adaption V.110 (1,200 up to 38,400 bps), V.120 up to 57,600 kbps (HSCSD) for connection to GSM
subscribers
Routing
Multicast IGMP Proxy For easy forwarding of multicast packets via dedicated interfaces
RIP Support of RIPv1 and RIPv2, separated configurable for each interface
Multicast IGMP Support of Internet Group Management Protocol (IGMP v1, v2, v3) for the simultaneous distribution
of IP packets to several stations
Extended RIP Triggerd RIP updates according RFC 2091 and 2453, Poisened Rerverse for a better distribution of
the routes; furthermore the possibility to define RIP filters for each interface.
Policy based Routing Extended routing (Policy Based Routing) depending of diffent criteria like IP protocols (Layer4),
source/destination IP address, source/destination port, TOS/DSCP, source/destination interface and
destination interface status
Multicast inside IPSec tunnel Enables the transmission of multicast packets via an IPSec tunnel
Protocols / Encapsulations
DNS DNS client, DNS server, DNS relay and DNS proxy
PPPoA Point to Point Protocol over ATM for establishing of PPP connections via ATM/DSL
DYN DNS Enables the registering of dynamic assigned IP addresses at adynamic DNS provider, e.g. for
establishing of VPN connections
DNS Forwarding Enables the forwarding of DNS requests of free configurable domains to assigned DNS server.
IPoA Enables the easy routing of IP via ATM
Packet size controling Adaption of PMTU or automatic packet size controling via fragmentation
MLPPPoE (Server/Client) Multilink extension MLPPPoE for bundeling several PPPoE connections (only if both sides support
MLPPPoE)
PPP/MLPPP Support of Point to Point Protocol (PPP) for establishing of standard PPP connections, inclusive the
Multilink extension MLPPP for the bundeling of several connections
DHCP DHCP Client, Server, Proxy and Relay for siplified TCP/IP configuration
PPPoE (Server/Client) Point-to-Point Protocol over Ethernet (Client and Server) for establisching of PPP connections via
Ethernet/DSL (RFC 2516)
Quality of Service (QoS)
Layer2/3 tagging Conversion of 802.1p layer 2 priorisation information to layer 3 diffserv attributes