Wireless Charging Desk Pad Manual
Flatten Your Wireless Charging Desk Pad Step 1 Stretch Your Desk Pad
Step 2 Roll up the edges in reverse way to the direction it curls and put it still for a short while
Step 3 Press slightly on the cylinder according to how severe it curls.
Step 4 Lay desk pad flat, if it still curls, repeat step 2 & 3.
How to use charging station 1. A USB cable comes in the package. Connect the USB C port to the desk pad. 2. Connect the USB A/C (switchable) on the other side to an adapter and plug into a power source. (USB C port and QC2.0/3.0/PD/AFC adapter are recommended to enable the max charging efficiency) 3. Place QI enabled charging device onto the charging area. Charging compatibility Max charging watt on standby flight mode 1. Input: 5-12V 2. Output: 15W(max) 3. Over voltage protection: >13V 4.
Indicators 1. Indicators are on for 5 sec when plugged into power source 2. Indicators are on while charging 3. Indicators show on and off while foreign object like metal, magnetic item, IC chip is detected. 4. Indicators are still on when device is fully charged, but charging has actually stopped. How to clean your desk pad 1. Normally, tissue or towel is enough to clean stains from coffee, tea or snacks. 2. Use wet towel to clean stains from oil or stains that existed for days. 3.
Note: 1. Actual charging efficiency is based on the quality of power source, adapter and charging device. Power via computer or adapter lower than QC2.0 may slow down charging. 2. Charging efficiency 75%. It reduces gradually as the distance between charger and charger receiver increases 3. It is normal that charging station gets warm to 95℉, please do not worry. 4. Do not place any foreign object between charging station and charging device.
FCC Caution This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.