power factor pro manual
Power Factor pro manual Pf-pro Features • Clear Tone Technology provides Power Factor correction with 45 amps peak current reservoir • SMP+ (Series Multi-Stage Protection Plus) with Extreme Voltage Shutdown (EVS) • LiFT (Linear Filtering Technology) with zero ground contamination • Four rear panel outlets • 12 amp rating, with circuit breaker • Three year limited warranty • Front panel meter to display incoming line voltage ranging from 90 to 128 volts additional Pf-pro r Features • Compact rack-mountable
power factor pro manual harmonics, and clarity you’ve been missing! Additionally, the Power Factor Pro is the most comprehensive power conditioner ever created for the serious musician. Furman’s Series Multi-Stage Protection Plus (SMP+) guards your equipment from voltage spikes that can damage your amplifier or other connected equipment. Furman’s SMP+ features unparalleled clamping voltage.
Power Factor pro manual 6. Clean your Power Factor Pro unit with a damp cloth only. Do not use solvents or abrasive cleaners. Never pour liquid on or into the unit. 7. Your Power Factor Pro unit should be serviced by qualified service personnel when: • The power supply cord or the plug has been frayed or cut. • Objects have fallen or liquid has spilled into the unit. • The unit has been exposed to rain or other moisture. • The unit does not appear to operate normally.
power factor pro manual (3) If all of the LEDs on the voltmeter flash, the input voltage is marginally high. Power to the Power Factor Pro’s outlets will remain on unless the incoming voltage rises above the Extreme Voltage Shutdown (EVS) cut-off voltage (135 - 140 volts). The Power Factor Pro’s voltmeter has a basic accuracy of plus or minus two volts, and extreme cold or heat may cause an additional one volt of error (four volts and two volts for Power Factor Pro E).
Power Factor pro manual T R O U B LE - S H O O T I N G G U I D E Three Year Limited Warranty 1.) Symptom: No power to the AC outlets. Possible Cause: Circuit breaker has tripped due to excessive load. Action Needed: Remove one piece of equipment from the Power Factor Pro unit, and push the square re-set tab into the circuit breaker bezel. 2.) Symptom: No power to the AC outlets, “Protection OK” indicator is not lit.
power factor pro manual TO THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. Manufacturer does not warrant against damages or defects arising out of improper or abnormal use of handling of the Product; against defects or damages arising from improper installation, against defects in products or components not manufactured by Manufacturer, or against damages resulting from such non-Manufacturer made products or components.
Power Factor pro manual Important Note: The Power Factor Pro must be the first AC power component connected to the AC mains! Regulators such as the Furman AR-1215 or UPS systems such as the SB-1000 must be connected to the Power Factor Pro’s output. This is due to the fact that the PF-Pro’s current reservoir may hinder the performance of a regulator, and worst case may cause damage in extreme power environments.
