SERIES II 16 AMP POWER CONDITIONERS
SERIES II 16 AMP POWER CONDITIONERS Furman Series II Features • SMP+ : advanced surge protection, extreme voltage shutdown, ultra-low clamping voltage • LiFT (Linear Filtering Technology) with zero ground contamination • E Models have 10 IEC rear panel outlets and one front panel outlet • PE models have 5 IEC rear panel outlets with a front panel circuit breaker, and 3 PowerCon rear panel outlets • BNC connector on the rear panel allows you to attach any standard (12VAC 0.
SERIES II 16 AMP POWER CONDITIONERS INTRODUCTION Thank you for purchasing a Furman Series II Power Conditioner, and congratulations on choosing the best protection for your electronics. Series II Power Conditioners feature Furman’s revolutionary SMP+ circuitry, as well as our exclusive Linear Filtering Technology (LiFT). Together, SMP+ and LiFT comprise what is, without question, the world’s most advanced and comprehensive transient voltage surge suppressor / conditioner.
SERIES II 16 AMP POWER CONDITIONERS WA R N I N G To reduce the risk of electrical shock, do not expose this equipment to rain or moisture. Dangerous high voltages are present inside the enclosure. Do not remove the covers. Refer servicing to qualified personnel only. The lightning flash with an arrowhead symbol is intended to alert all users to the presence of dangerous un-insulated voltages within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock.
SERIES II 16 AMP POWER CONDITIONERS ADDITIONAL F E A T U R E S All PL-PRO Series II models include an 8 foot, 1.5mm x 3 gauge heavy-duty power cable. A rear mounted BNC jack accepts any standard (12 VAC 0.5 amp) gooseneck lamp for rear rack illumination. PL-PRO SERIES II E, PE, DE & PDE These models feature LED rack lights which produce virtually no heat and provide an extremely long life span.
PL-PRO E II Rear Light Switch Voltmeter Light Tube Dimmer Power Switch/Circuit Breaker Circuit Breaker for IECs LED Light Tubes PL-PRO PE II Rear Light Switch Switched Outlet Light Tube Dimmer Voltmeter PL-PRO DE II Digital Voltmeter Switched Outlet 230 Rear Light Switch Light Tube Dimmer LED Light Tubes PL-PRO PDE II Power Switch/Circuit Breaker Circuit Breaker for IECs 230 Rear Light Switch Light Tube Dimmer PM-PRO E II Digital Voltmeter Switched Outlet 230 Rear Light Switch PM-PRO
SERIES II 16 AMP POWER CONDITIONERS O P E R AT I O N Retractable Rack Lights, Rear Panel Lamp and Dimmer Control: The PL-PRO E II, PL-PRO PE II, PL-PRO DE II and PL-PRO PDE II include a dimmer control for the two retractable front panel light tubes. Turn it clockwise to increase brightness of both light fixtures, or counterclockwise to decrease brightness. Turning the dimmer fully counterclockwise when the lights are not in use, will maximize the life of the LEDs: however, this is not absolutely necessary.
SERIES II 16 AMP POWER CONDITIONERS 2. If all of the LED’s on the voltmeter flash, the input voltage is marginally high. The PL-PRO’s outlets will remain powered unless the incoming voltage rises above the Extreme Voltage Shutdown cutoff voltage of 270 – 280 volts (UK version: 255 – 260 V). 3.
SERIES II 16 AMP POWER CONDITIONERS Protection OK Indicator: Although the Furman SMP+ circuit assures virtually impregnable protection against transient voltage spikes and surges, Nature occasionally creates electrical forces that are beyond the capacity of any TVSS device to absorb without incurring some degree of damage. In the rare instance that this occurs, the green “Protection OK” LED indicator located on your front panel will dim.
SERIES II 16 AMP POWER CONDITIONERS DEFINITIONS SPIKE: A pulse of energy on the power line. Spikes can have voltages as high as 6000 volts. Though they are usually of very short duration, their energy can be considerable, enough to damage sensitive solid-state components in audio and computer equipment. Spikes can also foul switch contacts and degrade wiring insulation. They are an unavoidable component of electric power.
SERIES II 16 AMP POWER CONDITIONERS Manufacturer shall, at its own expense, furnish a replacement Product or, at Manufacturer’s option, repair the defective Product. Return shipping charges back to Purchaser will be paid by Manufacturer. THE FOREGOING IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.
SPECIFICATIONS Current rating: 16 amps Make sure to pick up one of Furman’s gooseneck lights – the perfect accessory for your Series II Power Conditioner. Operating Voltage: 180 to 280 VAC (UK version, 260 VAC) Over Voltage Shutdown: 280 VAC typically (UK version, 260 VAC) Voltmeter Accuracy: PL-PRO E II / PE II: ±4 VAC, calibrated with internal trimpot adjustments PL-PRO DE II / PDE II & PM-PRO E II / PE II: ±1.5 VAC Current Meter Accuracy: PM-PRO E II / PE II: ±0.
