SP-20AB MANUAL 0008A 960026-832
SP-20AB MANUAL Important Note: To obtain best results from this Furman Sound electronic product, please be sure to read this manual carefully before using it. Please fill out and return the Warranty Registration Card immediately to obtain full protection under the terms of the Limited Warranty, in case your ownership documents are lost. Please verify that the serial number shown on the Warranty Card matches the serial number on your unit.
SP-20AB MANUAL The SP-20AB’s compact size and 20 watts per channel make it ideal for modular use in large commercial installations with multiple small speakers. Its power capacity is also just right for driving the small near field monitors used in most recording studios as a comparison with the main control room monitors - it can power them without overpowering them.
SATELLITE / RIGHT INP 120 VAC 60 Hz 130 Watts LEFT / MONO LIFT OFF SP-20AB MANUAL 5 6 2 1 7 8 0 10 L R 1 20 WATTS / CHANNEL STEREO AMPLIFIER SIGNAL INPUT LEVEL MODEL SP-20A OFF 120 VAC LIFT 60 Hz Input Level control can be INPUT LEVEL: The 130 Watts adjusted for maximum signal to noise and minimum clipping. The Input Level control is stereo - it affects both left and right channels simultaneously and affects all outputs.
6 2 1 7 8 0 10 L 9 OVERLOAD 1 SIGNAL 120 VAC 60 Hz 130 Watts LIFT MODEL SP-20A contact between chassis, as in a rack with metal rails. Sliding the Ground Lift switch up completely isolates all signal grounds from the chassis, breaking any ground loops. The chassis always remains connected to the ground pin on the AC cord for safety and to provide shielding against RF interference.
SP-20AB MANUAL two top (red) terminals. In this case, nothing other applications. The HR-2 units are compact should be connected to the bottom (black) boxes which easily attach with a thumbscrew terminals. Positive polarity will be on the left to any microphone stand Each HR-2 has two channel (red) terminal. stereo volume controls and two headphone SATELLITE/REMOTE OUTPUT: This output jacks. There are also two XLR connectors, one is a single male XLR connector containing male and one female.
SP-20AB MANUAL Installation For installation as a free-standing unit, attach the four adhesive rubber feet supplied with the SP-20AB to the bottom of its case. With either the HRKIT-1 or the HRKIT-2 adaptor kits the SP-20AB may be mounted in standard 19” equipment racks. The HRKIT-1 is for mounting one SP-20AB in the center of a 19” rack. The HRKIT-2 is for mounting two units side by side in a 19” rack (or for mounting a single unit in a “half rack”).
SP-20AB MANUAL Limited Warranty Furman Sound, Inc., having its principal place of business at 1997 South McDowell Blvd., Petaluma, CA 94954 (“Manufacturer”) warrants its SP-20AB (the “Product”) as follows: Manufacturer warrants to the original Purchaser of the Product that the Product sold hereunder will be free from defects in material and workmanship for a period of three years from the date of purchase.
SP-20AB MANUAL Service Before returning any equipment for repair, please be sure that it is adequately packed and cushioned against damage in shipment, and that it is insured. We suggest that you save the original packaging and use it to ship the product for servicing. Also, please enclose a note giving your name, address, phone number and a description of the problem. NOTE: All equipment being returned for repair must have a Return Authorizatilon (RA) Number.
SP-20AB MANUAL SPECIFICATIONS OUTPUTS: Power: Connectors: INPUTS: Input Impedance: Sensitivity: Connectors: GENERAL: Distortion: 20 Watts per channel, stereo, into either 4 Ohms or 8 Ohms, or 40 Watts mono into 8 Ohms, 20 Hz to 20 KHz Speakers: 5-way binding posts (accommodates dual banana plugs, spade lugs, bare wires, etc.) Remote Headphone: XLR. 20K Ohms. -6.5 dBU required for full output. XLR, balanced. .01 % THD at full rated power at 1 KHz; .05% THD 20 Hz to 20 KHz.
SP-20AB MANUAL
SP-20AB MANUAL Furman Sound, Inc. 1997 South McDowell Blvd. Petaluma, California 94954-6919 USA Phone: 707-763-1010 Fax: 707-763-1310 Web: www.furmansound.com E-mail: info@furmansound.
