User's Manual
5
FRANÇAIS
ENGLISH
ESPAÑOL
Since the banks are isolated from each other, it is recommended to connect analog equipment into Bank A and digital equipment
into Bank B (or vice versa). The PL-PRO C’s 20 amp (2400 wa) capacity is supplied from a robust 12 AWG, 10 foot AC cord.
Addionally, the PL-PRO DMC oers a switchable laboratory precision digital meter that displays incoming voltage in
1-volt steps or true RMS current in 0.1 amp steps. The voltmeter’s accuracy is ±1.5 volts and features a tri-color voltage range
indicator. This informs the user whether voltage is in or out of a safe range, even from a distance too great to accurately read the
displayed voltage.
SAFETY INFORMATION
To obtain best results from your Furman Classic Series power condioner, please read this manual carefully before using.
WARNING
To reduce the risk of electrical shock, do not expose this equipment to rain or moisture. Dangerous high voltages are present inside
the enclosure. Do not remove the cover. Refer servicing to qualied personnel only. The lightning ash with an arrowhead symbol
is intended to alert the user to the presence of uninsulated dangerous voltage within the product’s enclosure that may be of
sucient magnitude to constute a risk of electric shock.
IMPORTANT SAFETY INSTRUCTIONS
(Please read prior to installaon)
1. Please read and observe all safety and operang instrucons before installing your Furman Classic Series power condioner.
Retain these instrucons for future reference.
2. Your Classic Series condioner should not be used near water – for example, near a bathtub, washbowl, kitchen sink, laundry tub,
in a wet basement, or near a swimming pool.
3. Do not place your Classic Series condioner near high heat sources such as radiators, heat registers, stoves, or other appliances
that produce extreme heat.
4. The Furman PL-PRO DMC should only be connected to a 120 VAC, 50Hz/60Hz, 20 amp grounded electrical outlet. Do not defeat
the ground or change polarizaon of the power plug.
5. Route the AC power cord and other cables so that they are not likely to be walked on, tripped over, or stressed. Pay parcular
aenon to the condion of the cords and cables at the plugs and at the point where they exit your Furman condioner. To
prevent risk of re or injury, damaged cords and cables should be replaced immediately.
6. Clean your Furman condioner with a damp cloth only. Do not use solvents or abrasive cleaners. Never pour liquid on or into the
unit.
7. Your Furman condioner should be serviced by qualied service personnel when:
• The power supply cord or the plug has been frayed, kinked, or cut.
• Objects have fallen or liquid has been spilled into the unit.
• The unit has been exposed to rain or extreme moisture.
• The unit does not appear to operate normally.
• The “Protecon OK” indicator is not lit.
• The unit has been dropped, or the enclosure has been damaged.
• The retractable LED lights have failed.
8. Your Furman condioner requires that a safety ground be present for proper operaon. Any aempt to operate the unit without
a safety ground is considered improper operaon and could invalidate the warranty.
9. Do not aempt to service your Furman condioner beyond what is described in this manual. All other servicing should be
referred to qualied service personnel.
OPERATION
RETRACTABLE SMOOTH TRACK RACK LIGHTS, REAR PANEL LAMP AND DIMMER CONTROL:
The Furman Classic Series power condioners ulize a dimmer control for the two retractable Smooth Track light tubes. The dim-
mer knob controls the brightness of both front panel lamps. Turn it clockwise to increase brightness; turn it counterclockwise to
decrease brightness. The knob is also a momentary power switch for the lamps: push it in to turn the lamps on or o. When the