User Manual

again. Avoid turning the unit back on without rst checking the source

of the problem and perhaps changing the AC source.

Protection OK Indicator:

Although the Furman SMP+ circuit assures virtually maintenance-

free protection from transient voltage spikes and surges, nature

has a way of occasionally creating electrical forces that are beyond

the capabilities of any transient voltage surge suppressor device to

absorb without some degree of damage. In the rare instance that

this occurs, the blue “Protection OK” LED indicator will turn off. If this

happens, some level of protection from voltage surges will remain,

but Furman’s clamping voltage rating will be compromised. The

unit must be returned to Furman Sound, or an authorized Furman

Service Center for repair.

Mounting

If the Power Station needs to be mounted to the inside panel of a rack

or hung from a wall, a convenient crossed oval cutout is provided on

the unit’s bottom panel. A standard No. 6 pan head screw can be

used in the same way a picture is hung from a wall. Simply measure

the centers on the bottom of your Power Station. This will be the

distance from the two mounting holes drilled into your wall, rack or

cabinet surface. Once the screw is fastened ush with the surface,

back it out approximately ½”. The screw head should push through

the crossed cutout on the bottom surface of the Power Station. Next,

simply allow the Power Station to move down and seat into the end

of its oval cut-out. Adjust the pan head screw if necessary.