Assembly Instruction

ManualsBrandsFurniture of America ManualsBedroom SetsWynton 2 Piece California King Size Bedroom Set

Table Of Contents

Assembly Instructions

EASY

DIFFICULT

Page 1 of 7

ASSEMBLY RATING

The Assembly Rating is a 5-point system that

shows the degree of effort needed in

assembling a specific product (with 1 being

easy and 5 being difficult). For some

products, two persons are recommended.

2 PERSONS RECOMMENDED

Tools Required For Assembly:

Allen Wrench

(Included)

For more information contact our team: service.ec@foagroup.com

Rev:18-03-17

CM7360Q/EK/CK

Phillips Screwdriver

(Not Included)

Summary of content (7 pages)

PAGE 1
AssemblyInstructions For more information contact our team: service.ec@foagroup.com CM7360Q/EK/CK ASSEMBLYRATING Tools Required For Assembly: The Assembly Rating is a 5-point system that shows the degree of effort needed in Allen Wrench assembling a specific product (with 1 being easy and 5 being difficult). For some products,two persons are recommended.
PAGE 2
FOR YOUR FURNITURE TO LAST,CORRECT ASSEMBLY AND PROPER MAINTENANCE ARE NECESSARY. PLEASE FOLLOW THE INFORMATION PROVIDED BELOW TO FULLY ENJOY YOUR FURNITURE. BASIC ASSEMBLY TECHNIQUES When lock or spring washer is used inPosition each part correctly and insert Use cardboard or carpet area when an assembly, please make sure the screws or bolts into their respective assembling furniture to prevent lock or spring washer is placed holes by hand tighten or using the scratches.
PAGE 3
Before you begin, please read Page 2 of "Assembly and Care Advice". And remember, do not tighten until each step is completed or instructed.
PAGE 4
Before you begin, please read Page 2 of "Assembly and Care Advice". And remember, do not tighten until each step is completed or instructed.
PAGE 5
#G Align HB legs (#2R/L) to the holes of the headboard (#1), then secure by using bolts (#A) with washers (#B,C). #A #B #A x 6pcs #B x 6pcs #C x 6pcs #C #2R #B #G #1 #C #A #2L Attach support legs (#4) to the footboard (#3). Adjust the levelers of the support legs (#4) according to ground level.
PAGE 6
Align side rails (#5) to the holes of the headboard (#1) and footboard (#3), then secure by using bolts (#D) with washers (#E,F). #D x 8pcs #E x 8pcs #F x 8pcs #1 #F #D #E #G #5 #3 #5 Align center slat (#6) to the holes of the slat kit (#7). Secure by attaching support legs (#8) to the holes of the center slat (#6) with slat kit (#7). Adjust the leveler of the support legs (#8) according to ground level.
PAGE 7
Align slats to the side rails, then secure by using screws (#H). #H #H x 26pcs #7 #5 USB #5 Align dusty panels (#9) to the bed slats, then secure by using screws (#I).