Assembly Instructions ASSEMBLY RATING Tools Required For Assembly: The Assembly Rating is a 5-point system that shows the degree of effort needed in Allen Wrench inducer) } assembling a specific product (with 1 being easy and 5 being difficult). For some Socket Wrench products, two persons are recommended.
ASSEMBLY & CARE ADVICE FOR YOUR FURNITURE TO LAST, CORRECT ASSEMBLY AND PROPER MAINTENANCE ARE NECESSARY. PLEASE FOLLOW THE INFORMATION PROVIDED BELOW TO FULLY ENJOY YOUR FURNITURE BASIC ASSEMBLY TECHNIQUES When dock or spring washer is used in Position each part correctly and insert an assembly, please make sure the screws or hoist into their respective rock of spring washer is placed holes by hand tighten or using the between the larger flat washer and the proper hand tool.
Before you begin, please read Page 2 of "Assembly and Care Advice". And remember, do not tighten until each step is completed or instructed.
Before you begin, please read Page 2 of "Assembly and Care Advice". And remember, do not tighten until each step is completed or instructed.
1g bolts (#E) with then scour by unis, #1), } washers (HF).
#B x 1pc #C x PCs #F x PCs #G x PCs #H x PCs #l x PCs 2) Align middle shelf (#3) to the rods, then secure by using hex nut (Gy with washers #A x PCs #H x PCs 3) Attach rods (#A) and dowels (#H) 10 the holes of the middies shelf 3) Align and attach rods (#B) 10 the holes of the middies shell then place support tube (#7) with plastics washer (#1) over rods 1} Attach rods (#C) and dowels (#1) to the holes of the top wood Page 6of 7
#F x PCs #G x Specs #H x PCs Slide small side panel (#3) through the Todd Attach dowels (#H) to the holes of the side panels then align bottom panel (#2) 10 the rods and dowels of the unit.