Assembly Instructions ASSEMBLY RATING Tools Required For Assembly: The Assembly Rating is a 5-point system that shows the degree of effort needed in assembling a specific product (with 1 being easy and 5 being difficult). For some Allen Wrench products, two persons are recommended.
ASSEMBLY & CARE ADVICE FOR YOUR FURNITURE TO LAST CORRECT ASSEMBLY AND PROPER MAINTENANCE ARE NECESSARY. PLEASE FOLLOW THE INFORMATION PROVIDED BELOW TO FULLY ENJOY YOUR FURNITURE. BASIC ASSEMBLY TECHNIQUES When peek or spring washer is used in Position each part correctly and insert an assembly, please make sure the screws of hoist info their respective lock or spring washer is placed holes by hand tighten or using the between the larger flat washer and the paper hand tool.
Before you begin, please read Page 2 of "Assembly and Care Advice". And remember, do not tighten until each step is completed or instructed.
#AxBpcs #BxBpcs #Capes #Ax3pcs #Bx3pcs #Cx3pcs Align the shelf (#2) to the holes along the fees then insert a obit assembly into the holes and secure using the Allen wrench. 2. Prepare & bolt assemblies by fir; inserting a lock washer (#C) ont the bolt {#A) then a flat washer (B} onto that same bolt the table top Insert 2 bo assemblies into each leg and secure using the Allen wrench.
1. Prepare 3 bolt assemblies by first inserting a ! lock washer (BC) onto the bolt (#A} then a fiat washer (#8} onto that same bolt #Ax3pcs #Bx3pcs #Cx3pcs WZA Aligner the fourth {#3) to the final corner and insert a bolt assembly inch each hole, Secure ieg using the Allen wrench Carefully turn the completed table upright. Make sure the table is tasted on a flat surface and does not feel loos or wobbly. If it does, double check that the bolts are secured and properly tightened. Insert Drawer.