Instructions / Assembly

ManualsBrandsFurniture of America ManualsAccent TablesArthur Black 3-Piece Table Set

EASY

The Assembly Rating is a 5-point system that

shows the degree of effort needed in

assembling a specific product (with 1 being

easy and 5 being difficult). For some

products, two persons are recommended.

CM4848-3PK

Assembly Instructions

Tools Required for Assembly:

Rev.14-10-20

Page 1 of 8

DIFFICULT

ASSEMBLY RATING

Allen Wrench

2 PERSONS RECOMMENDED

(Included)

Summary of content (8 pages)

PAGE 1
Assembly Instructions CM4848-3PK ASSEMBLY RATING Tools Required for Assembly: The Assembly Rating is a 5-point system that shows the degree of effort needed in assembling a specific product (with 1 being easy and 5 being difficult). For some products, two persons are recommended. EASY Allen Wrench (Included) DIFFICULT 2 PERSONS RECOMMENDED Page 1 of 8 Rev.
PAGE 2
Page 2 of 8
PAGE 3
Before you begin, please read Page 2 of “Assembly and Care Advice”. And remember, do not tighten until each step is completed or instructed.
PAGE 4
#A x 1 pc #D x 1 pc #E x 1 pc Turn right (clockwise) to tighten I. Align the coffee table cross stand B (#2) with the pre-drilled hole of the coffee table cross stand A (#1). II. Prepare a bolt assembly by inserting FIRST the lock washer (#E) onto the bolt #A) and then the flat washer (#D) onto the SAME bolt (#A), in that order. III. Insert the bolt assembly through the coffee table cross stand A (#1) using the Allen wrench (#F) to lock it with the coffee table cross stand B (#2).
PAGE 5
I. Prepare a bolt assembly by inserting FIRST the lock washer (#E) onto the bolt (#B) and then the flat washer (#D) onto the SAME bolt (#B), in that order. II. .Insert the bolt assembly through the coffee table stand B support (#3) using the Allen wrench (#F) to lock it with the coffee table cross stand A (#1). #B x 1 pc #D x 1 pc #E x 1 pc Turn right (clockwise) to tighten #3 #G x 4 pcs I. Insert 4 suction cups (#G) into the coffee table cross stand A (#1) and coffee table cross stand B (#2). II.
PAGE 6
Before you begin, please read Page 2 of “Assembly and Care Advice”. And remember, do not tighten until each step is completed or instructed.
PAGE 7
Turn right (clockwise) to tighten #A x 2 pcs #D x 2 pcs #E x 2 pcs I. Align the end table cross stand B (#2) with the pre-drilled hole of the end table cross stand A (#1). II. Prepare a bolt assembly by inserting FIRST the lock washer (#E) onto the bolt #A) and then the flat washer (#D) onto the SAME bolt (#A), in that order. III. Insert the bolt assembly through the end table cross stand A (#1) using the Allen wrench (#F) to lock it with the end table cross stand B (#2).
PAGE 8
I. Prepare a bolt assembly by inserting FIRST the lock washer (#E) onto the bolt (#B) and then the flat washer (#D) onto the SAME bolt (#B), in that order. II. .Insert the bolt assembly through the end table stand B support (#3) using the Allen wrench (#F) to lock it with the end table cross stand A (#1). #B x 2 pcs #D x 2 pcs #E x 2 pcs Turn right (clockwise) to tighten #3 #G x 8 pcs I. Insert 4 suction cups (#G) into the end table cross stand A (#1) and end table cross stand B (#2). II.