Furniture America TM E-commerce Division - Enitial Lab ITEM#:161719 ASSEMBLY RATING Tools Required for Assembly: The Assembly Rating is a 5-point system that shows the degree of effort needed in Phillips Screwdriver assembling a specific product (with 1 being easy and 5 being difficult). For most products,two persons are recommended.
Furniture America TM E-commerce Division - Enitial Lab Thank you for your purchase! We hope you wiIl enjoy your new product for many years to come. Our commitment to providing quality products does not simply end when a purchase is made. We stand behind our products and will provide any support needed in order for you to fully enjoy your purchase. Your satisfaction is the greatest recognition we could have. Because we value your trust in our company,we will do our best to meet your service expectations.
Furniture America TM FOR YOUR FURNITURE TO LAST,CORRECT ASSEMBLY AND PROPER MAINTENANCE ARE NECESSARY PLEASE FOLLOW THE INFORMATION PROVIDED BELOW TO FULLY ENJOY YOUR FURNITURE. BASIC ASSEMBLY TECHNIQUES It is highly recommended that the assembly should be done near the area of its intended location. Make sure you have enough space to move around during the assembly. Position each part correctly and insert screws or bolts into their respective holes by hand tighten or using the proper hand tool.
Unless you are particularly adept at assembling flat-pack/knock-down furniture, we understand building ready-to-assemble furniture can be a frustrating experience for some. To help avoid confusion and to make the assembly process quicker and smoother, we have provided some helpful tips. Before you begin the assembly, please read the following : 1. 2. 3. 4. 5. 6. 7.
Note:Every cam lock bolt must have a cam lock connector in order to fasten the parts together. (1) Align the cam connector with its side opening (or arrow) pointing to the small driIIed hole. Secure the threded end of the cam bolt by using a screwdriver. Tun right (clokwise) to tighten. (3) (2) Insert the cam lock bolt into the pre-drllled hole above the cam connector. Two parts should fit snugly against each other.
Before you begin,please read"Assembly and Care Advice","Pre-Assembly Introduction"and "Cam Lock Fastener Assembly Instructions".
Due to the size and/or weight of this product,it is highly recommended that the assembly should be done near the area of its intended location.Make sure you have enough space to move around during the assembly.
Due to the size and/or weight of this product,it is highly recommended that the assembly should be done near the area of its intended location.Make sure you have enough space to move around during the assembly.
4 6 Hх2 Page 9 of 17
Page 10 of 17
14 1 4 Page 11 of 17
Mх5 Wх2 N Oх5 Eх5 11 Page 12 of 17
Page 13 of 17
8 9 9 8 Page 14 of 17
2 Page 15 of 17
Page 16 of 17
Q×2 J×4 R×2 K×4 ASSEMBLY IS COMPLETED Make sure the unit is rested on a flat surface and does not feel loose or wobbly If it does,double check that the bolts/screws are secured and properly tightened Page 17 of 17
Anti-Tipping strap lnstruction Hardware List (Included): STEP 1 STEP 2 STEP 3 STEP 4