ik Furniture of America E-commerce Division Initial Lab ASSEMBLY INSTRUCTIONS 192651 ASSEMBLY RATING The Assembly Rating is a 5-point system that shows the degree of effort needed in assembling a specific product (with 1 being easy and 5 being difficult). For most products,two persons are recommended. EASY OOH@ DIFFICULT Tools Required for Assembly: Phillips Screwdriver E=Sg—— (Not Included) Hammer .
— Furniture of America E-commerce Division Initial Lab Thank you for your purchase! We hope you will enjoy your new product for many years to come. Our commitment to providing quality products does not simply end when a purchase is made. We stand behind our products and will provide any support needed in order for you to fully enjoy your purchase. Your satisfaction is the greatest recognition we could have. Because we value your trust in our company,we will do our best to meet your service expectations.
Al Furniture of America ASSEMBLY & CARE ADVICE FOR YOUR FURNITURE TO LAST,CORRECT ASSEMBLY AND PROPER MAINTENANCE ARE NECESSARY PLEASE FOLLOW THE INFORMATION PROVIDED BELOW TO FULLY ENJOY YOUR FURNITURE. BASIC ASSEMBLY TECHNIQUES It Is highly recommended that the Position each part correctly and insert Use cardboard or carpet area when assembly should be done near the craws or bolts into their respective assembling furniture to prevent area of its intended location.
PER-ASSEMBLY INTRODUCTION Unless you are particularly adept at assembling furniture, we understand building ready-to-assemble furniture can be a frustrating experience for some. To help avoid confusion and to make the assembly process quicker and smoother, we have provided some helpful tips. Before you begin the assembly, please read the following : 1.
CAM LOCK FASTENER ASSEMBLY INSTRUCTIONS Note:Every cam lock bolt must have a cam lock connector in order to fasten the parts together. Align the cam connector with its (1 ) Secure the threaded side opening (or arrow) end °_f the cam bolt 1 pointing to the small by using a drilled hole. screwdriver. Tun right (clockwise) to tighten. (2) (3) Two parts should fit snugly l Insert the cam lock against each other. bolt into the per-drilled hole l < above the cam @ connector.
PARTS LIST (1) Ipc | (8 1pc | (15) PCs | (22) Ipc ) 1pc @ 1pc (16) 1pc (23) apes (3 Ipc | (10) 1pc | (I7) PCs | (24) Ipc 4 lpc | (1) 1pc | (18) 1pc (25) 1pe (5) 1pc | (12) 1pc | (19) 1pc | (26) 1pc 6 Ipc | (13) 1pc | (200 1pc (7 1pc | (14) PCs | (21) 1pc . Before you begin,please read"Assembly and o Care Introduction"and "Cam Lock Fastener Assembly Instructions™.
HARDWARE LIST @ Glue: For securing please apply to wood 1 | _ 7U7 loved first before inserting into panel 23.5X14 PCs Due to the size and/or weight of this product,it is highly recommended that the assembly should be done near the area of its intended location.Make sure you have enough space to move around during the assembly.
ASSEMBLY INSTRUCTIONS % SAFETY STRAP TO PREVENT TIP OVER SAFETY STRAP TO PREVENT TIP-OVER Drywall: Select a location where you want the table to be mounted. Place the assembled table against the wall and, on the wall, mark the location where the anchor will be placed. Di rill a hole slightly smaller then the size of the screw . Push the anchor as far as it will go with your finger. Tap gently with a hammer until the anchor is flush with the wall surface.