Owners Manual

8
Installation
English
B. Mounting on a wood stud wall
covered with gypsum board
(drywall)
1. Use a stud finder to firstly find both the
edges of the wooden stud. Locate the
center of each wooden stud and mark the
center lines for two studs.
Note: Drywall covering the wood stud
wall must not exceed 16 mm (/").
2. Place the wall plate paper template
against the wall to ensure the 4 holes line
up with the stud center lines. Level the
wall plate paper template and paste it in
place.
Note: This is the drilling template to be pasted
on wall for drilling holes easily and safely.
Drill here
(16" apart)
Drill here
(16" apart)
Drill here
(16" apart)
Drill here
(16" apart)
16 in. (406.4 mm) apart
Drill here for solid concrete or concrete block wall only Drill here for solid concrete or concrete block wall only
Paper Template
Note: The mounting hole must be
centered on the stud.
3. Using a ⁄" (5.5mm) drill bit, drill 4pilot
holes. Then remove the wall mount paper
template from wall.
Note: Pilot holes must be drilled to a
depth of 3" (75 mm).
Note: This is the drilling template to be pasted
on wall for drilling holes easily and safely.
Drill here
(16" apart)
Drill here
(16" apart)
Drill here
(16" apart)
Drill here
(16" apart)
16 in. (406.4 mm) apart
Drill here for solid concrete or concrete block wall only Drill here for solid concrete or concrete block wall only
4. Install the wall plate on wall using 4lag
bolts(A) and washers (B). Tighten the lag
bolts securely so that wall plate is firmly
attached to wall.
Warning: Do not over tighten.