User's Manual

Fig. C

Fig. D

Tabletop Charging Base Installation (FBS012NEP only)

1. Slide the speaker into the charging base until securely attached onto

the charging base as shown below. Do not installed inversed. (Fig. E)

2. Turnover the speaker with the bottom of the charging base facing up

and install 4 rubber feet onto the charging base as shown. (Fig. F)

Fig. E

Fig. F

Charging your Speaker

Before using the speaker, you must charge the device for a minimum of

5 hours using Micro USB Charing Port or 3.5 hours (minimum) using the

charging base. You may check the power level by short pressing the

button before operating your speaker each time. The power indicator will

be illuminated in white for 3 seconds to show the current power level and

then disappear.

– 5 Light: 80%-100%

– 4 Light: 60%-80%

– 3 Light: 40%-60%

– 2 Light: 20%-40%

– 1 Light: 0-20%

It is recommended you fully charge the battery before using for the ﬁ rst

time. The speaker can be charged in three ways:

● If a genuine Furrion charging base is installed, place the speaker

into the charging base to charge. The speaker will be fully charged in

approximately 3.5 hours.

● Lift to open the rubber cap at the end of the speaker. Connect one end

of the adapter to the Micro USB Port on the speaker and the other end

to a 5V DC outlet. The speaker will be fully charged in approximately

5 hours.

Installation Before Using