Operator's Manual
1. OPERATION
1-29
1.9.2 Displaying, editing regional operating area status
You may display the status of regional operating areas currently memorized in
the equipment. Nine of any combination of AIS message from shore-based AIS,
DSC message, manual settings and commands from ECDIS or a PC may be
registered and one will be a default value.
About registering areas
• AIS and DSC messages registered within last two hours cannot be edited.
• An item labeled DEFAULT cannot be registered. (“DEFAULT” are data used
for international waters not controlled by shore-based AIS.)
• If two areas overlap one another the older data is deleted.
• Data older than five weeks is deleted.
• Area data is deleted when it is more than 500 miles from the area for which it
was registered.
1. Press the [MENU] key to open the menu.
2. Choose SET CHANNEL and then press the [ENT] key.
3. Choose EDIT CHANNEL and then press the [ENT] key.
[EDIT CHANNEL]
SELECT NO. : 0
TIME
- -/- - - - -: - -: - -
FROM
MMSI: DEFAULT
TYPE: DEFAULT
QUIT [MENU] EDIT[ENT]
EDIT CHANNEL sub-menu, page 1
SELECT NO.: File number, 0-9. In order of distance from own ship,
from closest to furthest.
TIME: Data and time equipment controlled by external source.
MMSI: MMSI displayed for control by DSC or shore-based AIS.
Dashes or “EMPTY” (no data) otherwise.
TYPE: How channel is controlled: AIS, AIS message; PI, ECDIS or
PC; DSC, DSC, MANUAL, manual control
Note: MMSI and TYPE must be set to other than “DEFAULT” to edit.
4. Use ▼ or ▲ to choose desired file number from SELECT NO. and then
press the [ENT] key.