Operator's Manual

1. OPERATION
1-30
5. Press the [ENT] key to show details.
Note: Power is fixed at 1W for
CH No. 1013 and/1067.
[EDIT CHANNEL] 1/2
FROM MMSI:
POWER : 12.5W
CH NO. CH-A: 2087
CH-B: 2088
MODE CH-A: TX/RX
CH-B: TX/RX
ZONE: 1nm
EDIT CHANNEL sub-menu, page 1
6. POWER is selected; press the [ENT] key to show the channel power
options.
1W
2W
12.5W
7. Use ▼ or ▲ to choose power desired and then press the [ENT] key.
8. CH NO. CH-A is selected; press the [ENT] key.
9. Use the CursorPad to choose channel number for CH-A and then press the
[ENT] key.
10. CH NO. CH-B is selected; press the [ENT] key.
11. Use the CursorPad to choose channel number for CH-B and then press the
[ENT] key.
12. MODE CH-A is selected; press the [ENT] key.
TX/RX
RX
UNUSED
13. Use the CursorPad to choose desired mode for CH-A and then press the
[ENT] key.
14. MODE CH-B is selected; press the [ENT] key.
15. Use the CursorPad to choose desired mode for CH-B and then press the
[ENT] key.
16. ZONE is selected; press the [ENT] key.
17. Key in the zone distance and then press the [ENT] key. (The setting range
is 1 to 8 (nm).) Then, the following screen appears.
[EDIT CHANNEL] 2/2
CH AREA
RIGHT TOP
LAT:
0
° 00.0'N
LON: 0
° 00.0'E
LEFT BOTTOM
LAT: 0 ° 00.0'N
LON: 0
° 00.0'E
CHANNEL EDIT sub-menu, page 2
18. LAT of RIGHT TOP is selected; press the [ENT] key. Use the CursorPad to
enter latitude for the right-top position (northeast point) of the AIS operating
area and then press the [ENT] key.