User Manual

1. OPERATIONAL OVERVIEW
1-5
1.1.3 Indications on the LCD
Below are all the indications which appear on the standby display on the
transceiver unit.
INTL
1
2
3
4
5
6
7
8
9
10
11
12
13
14
Hi
RX
DUP
116
SCAN
SHIFT
AUTO ACK
WATCH CH70 *
LAT: 34 45' N
°
10:45 UTC
LON: 135 45' E
°
AUTO
Standby display on the transceiver unit
Reference no. meaning
①
Displays the channel mode.
(INTL / USA / WX / CANADA / INLND-WA / (MEMO))
②
SHIFT is displayed if the shift function is active. Or memory number (for
example MEMO 01) is displayed at the MEMO mode.
③
Displays the scan mode: SCAN, DUAL or no display. During the scan
mode, channel indications are changed alternatively. No display means
that the unit receives continuously on the same channel.
④ Lights when the loudspeaker is off. Goes off when the loudspeaker is on.
⑤
Displays the transmission output.
(Hi=25W / Lo=1W)
⑥
Displays reception signal strength by 4 steps.
1. No signal. Only antenna mark is displayed.
2. Less than 37.6 dB (-100.6 dBm) SINAD：antenna mark and short bar
3. 40.0 dB (-96.9 dBm) SINAD and more：antenna mark and two bars
4. 41.9 dB (-92.9 dBm) SINAD and more：antenna mark and three bars
⑦
RX is displayed during reception and TX is displayed when
the RF signal detected at transmission state.
⑧
Displays the current channel.
（PRIV channel: max three digits）
⑨
Is displayed when the DSC routine call is received.
AUTO ACK: Automatic acknowledge
MANUAL ACK: Manual acknowledge
⑩
WATCH CH70 or WATCH VHF is selected at menu.
If the CH70 board is defective, WATCH CH70 NG appears.
⑪ Displays the longitude and latitude of own ship.
⑫ Displays UTC time.
⑬
Displays AUTO for automatic data input (L/L, time data) from a navigation
device or MANUAL for manual data input.
⑭ Displays when un-read message(s) exist.
*: If no MMSI is registered, the message “DSC NOT USABLE” appears.