User's Manual Part 2

7. NBDP SYSTEM OVERVIEW
7-7
Function key F6: [System] menu
The [System] menu is mainly for use by technicians and contains diagnostic tests. To
change settings, select [Change] from the item [Setup] and operate the arrow keys to
select item and option. Press the Enter key to register the selection and close the
menu.
Menu item Function
[Setup] Lock, change settings, restore default system settings.
[Slave Delay] Set the length of the slave delay timing from the end of RX to the start
of TX in the ARQ mode. The default setting is suitable in most cases.
This item cannot be adjusted by the user.
[TX/RX MSG
Save]
Turn on to automatically save incoming and outgoing messages to a
floppy disk or a SD card. "Log" appears at the top of the screen when
on.
[Edit Before
sending]
[OFF] transmits key operation one by one. [ON] transmits message
only when the Enter key is pressed after confirming text typed.
[TX POWER]
(only for
IB-585)
Change output power during transmission. ([HIGH], [MID], [LOW] (for
FS-1575/2575), [LOW1] (for FS-5075), [LOW2] (for FS-5075))
[Header/Foot-
er] (only for
IB-585)
Turn on or off the indication of header and footer. When starting trans-
mission, display time & date for starting transmission, MMSI for com-
munication party, TX and RX frequencies. When ending transmission,
display time & date for ending transmission.
[Time System] Select time system.
[OFF]: No time indication, [UTC]: Coordinated universal time,
[SMT]: Local time, [JST]: Japan standard time
Setup
Slave Delay
TX/RX MSG Save
Edit before Sending
TX Power*
Header/Footer*
Time System
Time & Date
Window Color
Self Test
Lock Change Default
12 msec (10 - 50 msec)
OFF ON
OFF ON
HIGH MID LOW
OFF ON
OFF UTC SMT JST
10-Apr-2012 10:00:00
System
*: Only for IB-585
ARQ
mode
signal
sequence
3 char. RX
3 char. RX
Slave Delay
Timing
RX end
TX start
ACK signal