User's Manual

4. INSTALLATION
4-9
4.6 Setting of Printer
After the connection completely, the setting of printer should be done for
NX-700B as shown below. (For NX-700A, use the default setting as is.)
1. Press the
key to turn the power on.
2. Press the MENU key to show the main menu.
Menu
NAVTEX
System
Display
Service
3. Press ▼ to choose System, and then press the ENT key or ► to activate the
System menu.
System
Warn Msg Alm Off
Signal Monitor Off
Key Beep Off
Time Offset +00:00
Units nm, kt
Printer NX-700A
4. Press ▼ to choose Printer, and then press the ENT key or ► to show the
item window.
None
NX-700A
Upright
Inverted
5. Press ▲ or ▼ to choose the appropriate setting, and then press the ENT
key.
NX-700A: For NX-700A only.
Upright: When NX-700B is connected with the upright type printer which ejects
the paper from bottom to top direction.
Inverted: When NX-700B is connected with the wall-hung type printer which
ejects the paper from top to bottom direction.
6. Press the MENU key several times to close the menu.