Operator's Manual Part 1

1. OPERATIONAL OVERVIEW
1-17
4. Use the cursor pad to select simulation mode desired and press the RETURN
soft key.
SIMULATION MODE (Plotter, sounder): Turns simulation mode on.
SIMULATION MODE 1 (Radar): Uses standard demonstration display.
SIMULATION MODE 2 (Radar): Uses data read into the unit from a network
radar.
LIVE: Turns simulation mode off.
5. Select SIMULATION SPEED and press the EDIT soft key.
6. Enter speed (setting range, 0-99 kt, default speed, 10 kt) with the [ENTER]
knob and press the RETURN soft key.
7. Select SIMULATED LAT and press the EDIT soft key.
8. Enter latitude (setting range, 85
°N-85°S, default setting, 45°37’N) and press
the RETURN soft key.
9. Select SIMULATED LON and press the EDIT soft key.
10. Enter longitude (setting range, 180
°E-180°W, default setting, same as GPS
default setting) and press the RETURN soft key.
11. Select SIMULATION START TIME and press the EDIT soft key.
12. Enter start date and time (default date and time: 2001/1/1, 0:0) and press the
RETURN soft key.
13. If you selected SIMULATION MODE 2 at step 4, select YES and press the
RETURN soft key. Press the [ENTER] knob to erase simulation data and get
new data. The message “Now getting demo data. Do not cut off display unit.”
appears while the unit is receiving radar data.
If the network radar could not be found “Radar source is not found. Cannot get
demo data.” appears. And if the radar is not active, the message “Radar is not
active. Cannot get demo data.” is displayed.