User Manual Part 2

1. DESCRIPTION OF OPERATION
1-52
5. Use the Cursorpad (S or T) to select [Sect-Blank 1 (or 2) Start] and press the
ENTER key.
Sect-Blank Start setting window
6. Use the Cursorpad (S or T) to set the start point of the sector and press the EN-
TER key.
7. Use the Cursorpad (S or T) to select [Sect-Blank 1 (or 2) End] and press the EN-
TER key.
Sect-Blank End setting window
8. Use the Cursorpad (S or T) to set the end point of the sector and press the EN-
TER key.
Note 1: You can not set the sector more than 180 degrees.
Note 2: You can not set the total width of sector 1 and sector 2 more than 270
degrees.
9. Press the MENU key to close the menu.
As shown in the following illustration, dashed lines mark the start and end points of the
sector.
Sector blank
+
Area of no
transmission
Start bearing
of sector
End bearing
of sector