Users Manual Part 5

3. TARGET TRACKING (TT)
3-12
7. Referring to the following table, select the item you want to edit.
8. Right-click to close the window.
3.9 How to Display/Remove Target Data
The TT mode provides the full functionality of TT as required by the IMO Resolution
A.823(19) and IEC 62288, including display of range, bearing, course, speed, CPA
and TCPA of all tracked targets.
The target bearing is shown in relative bearing in the HEAD UP mode and true bearing
in the COURSE UP, NORTH UP and True Motion modes, with the suffix "R" (Relative)
or "T" (True).
The target speed and course are shown as speed over the ground or speed through
the water depending on speed source.
3.9.1 TT pop up information
The TT pop-up shows abbreviated TT data for the selected TT. Simply put the cursor
on the TT symbol to show the pop-up. The following figure shows pop-up examples.
The popup can be enabled or disabled with the following procedure.
1. Open the menu.
2. Select [5 TT•AIS].
3. For IMO-types, select [4 TT•AIS SYMBOL], then select [0 NEXT].
For C-types, select [3 TT•AIS SYMBOL], then select [0 NEXT].
4. Select [6 TT POP-UP INFO].
5. Select [ON] or [OFF] as required.
6. Close the menu
Menu item Description
[SMBL COLOR] Change the symbol color for the selected preset.
[SMBL SHAPE] Change the symbol shape for the selected preset.
[TRACK COLOR] Change the track color for the selected preset.
[TGT NAME] Assign/change the target name.
Note: The software keyboard appears inside the editing win-
dow. See section 1.5.3 for how to use the keyboard.
TT No. Label* Name*
For C-types, course
and speed appear
as “CRS” and “SPD”
respectively.
Current track setting
*: Label and Name
appear only when
assigned.
TT No.
C-type IMO-type