Users Manual Part 6

5. PLOTTER OPERATION (IMO-TYPES)
5-2
• [ORIGIN MARK(SYM)]: Inscribes an origin mark symbol, with no mark number.
You can set one of the following symbols as the origin mark. See
section 5.5 for
details.
• [MAP MARK]:
Inscribes the selected map mark.
• [WP1-50], [WP51-100], [WP101-150], [WP151-198]: Inscribes a waypoint mark-
er number within the selected range. For detailed information regarding waypoints,
see
section 5.9.
• [OWN SHIP SHAPE]:
Inscribes a mark with the same shape as own ship. For de-
tailed information regarding the own ship mark, see
section 5.6.
6. Close the menu.
5.3 How to Select the Mark Inscription Position
You can select the location at which the marker is inscribed from the following:
1. Open the menu.
2. Select [2 MARKS].
3. Select [5 RADAR MAP].
The [RADAR MAP] menu appears.
Note: You can also right-click the [MARK] box to open the [RADAR MAP] menu.
4. Select [4 MARK POSITION].
5. Referring to the table above, select the appropriate location, then press the EN-
TER MARK key.
How to set the co-ordinates
Where [4 MARK POSITION] is set to [L/L], the co-ordinates settings are dis-
played. Co-ordinates can be set one digit at a time, as shown in the figure below.
1) Spin the scrollwheel to change the value, then left-click to move to the next
digit.
2) Repeat step 1 to adjust the Latitude and Longitude as appropriate.
6. Close the menu.
Location Description
[CURSOR] You can select the location using the Control Unit.
[OWN SHIP] Marker is placed at own ship position.
[L/L] Marker is placed at the co-ordinates selected.
028º 00.200 S
153º 43.100 E
Currently selected digit is highlighted by the cursor.
Left-click to move to the next digit.
Roll the scrollwheel to change the value.
N - North (Latitude)
S - South (Latitude)
W - West (Longitude)
E - East (Longitude)