Users Manual Part 6

5. PLOTTER OPERATION (IMO-TYPES)
5-15
5.9.4 How to erase waypoints
There are two methods to erase individual waypoints: cursor selection or from the
menu.
How to erase a waypoint by cursor selection
1. Place the cursor inside the operational display area, then right-click.
2. Select [MARK DELETE]. The mark delete function is activated and the cursor is
highlighted when inside the operational display area.
3. Select the waypoint you wish to delete, then left-click.
4. Right-click inside the operational display area to deactivate the mark delete func-
tion.
How to erase a waypoint from the menu
1. Open the menu.
2. Select [8 NAVLINE•WPT].
3. Select [6 WPT SET].
4. Select [2 WPT NO. SELECT]. Then select the waypoint to erase.
5. Select [5 CLEAR DATA].
6. Select [YES] or [NO] as appropriate, then left-click.
7. Close the menu.
How to erase all waypoints
You can erase all waypoints from the menu. If there is an active route, this procedure
cannot be completed.
1. Open the menu.
2. Select [2 MARKS].
3. Select [8 DELETE DATA].
4. Select [3 ALL WAYPOINTS].
5. Select [YES] to erase all waypoints. Select [NO] to cancel the procedure.
Note: All routes are also deleted with this procedure.
6. Close the menu.