Users Manual Part 6

5. PLOTTER OPERATION (IMO-TYPES)
5-19
5.10.4 How to set the route width
You can set a width for each route (NAV LINE). For example, if you
set a 5 NM route width, the route width is 5 NM to port and star-
board, with the own ship as the center. The route width is displayed
as orange dotted lines to either side of the route line.
To set a route width, do the following:
1. Open the menu.
2. Select [8 NAVLINE•WPT].
3. Select [5 NAV LINE WIDTH].
4. Spin the scrollwheel, or use the numeric keys, to set a width for
the route. To disable the route width alert and hide the route
width lines, set the width to [0.00 NM].
Note: This width is applied to all routes.
5. Close the menu.
5.10.5 How to show/hide the turning line
You can show or hide the turning line, the point at which your vessel starts a turn in a
route.
1. Open the menu.
2. Select [8 NAVLINE•WPT].
3. Select [0 NEXT].
4. Select [3 TURNING LINE].
5. Select the appropriate setting,
referring to the list below.
• [OFF]: Turning line is hidden.
• [ON]: Turning line is dis-
played.
• [REVISED]: Turning line is
displayed, but offset based
on the route and current own
ship position.
6. Close the menu.
Waypoint 2
: Route line
: Width line
Waypoint 1
Route
width
Own
ship
Estimated course with
no offset calculation*
Estimated course with
offset calculation*
*: Estimated course
is not displayed
on-screen.
: Route
: Track
: Turning line
Own shipOwn ship
[
TURNING LINE
]
set to
[
ON
]
[
TURNING LINE
]
set to
[
REVISED
]