Users Manual Part 6

6. PLOTTER OPERATION (C-TYPES)
6-4
6. Select [ON] or [OFF] as required.
7. Select [1 BACK] to return to the [TRACK] menu.
8. Select [8 OTHER TRACK SETTINGS].
9. Select [7 OTHER CURR VCT DISP.].
10. Select [ON] or [OFF] as required. For [ON], go to the next step to set the current
measuring layers to use.
11. Select [1 BACK] to return to the [TRACK] menu.
12. Select [0 NEXT].
13. Select [3 SET CURRENT LAYER].
14. Select [1LAYER]. Spin the scrollwheel to set the
measuring layer (1 to 5) to use.
15. Do the same for [2LAYER], [3LAYER].
16. Close the menu.
How to automatically display the tracks of acquired TT
You can automatically display the tracks of acquired TT as follows.
1. Open the menu.
2. Select [2 MARKS•PLOTTER].
3. Select [3 TRACK].
4. Select [9 OTHER TRACKS DISPLAY].
5. Select [4 TT TRACKS DISPLAY].
6. Select [ON] or [OFF] as required.
• [ON]: Track of all TT is displayed.
• [OFF]: Track of TT is not displayed. To show the track of a TT, do the following:
1) Put the cursor within the radar effective radius, then right click to show the
[CURSOR] menu.
2) Select [TRACK ON-OFF].
3) Click the TT whose track you want to show.
4) Right-click to finish.
7. Close the menu.