Users Manual Part 6

6. PLOTTER OPERATION (C-TYPES)
6-5
6.1.3 How to set own ship track recording
How to start/stop recording own ship track
You can stop recording own ship track when the ship is anchored for an extended pe-
riod or in port. This will help present unnecessary recording of track points.
1. Put the cursor within the radar effective radius, then right click.
2. Select [TRACK ON-OFF].
3. Right-click within the radar effective radius until the “Hold” icon ( ) appears.
Each click selects a track recording interval or stops recording in the following se-
quence.
When recording is stopped, the appearance of the own ship mark changes from
filled circle ( ) to a pair of concentric circles ( ).
4. Right-click to finish.
To restart recording, repeat the above procedure to show the recording interval 1 icon
( ) or recording interval 2 icon ( ). The own ship mark changes from ( ) to
().
Note: For RCU-031 users, you can also press TRACK ON/OFF to toggle recording.
How to show/hide track without recorded them
1. Open the menu.
2. Select [2 MARKS•PLOTTER].
3. Select [3 TRACK].
4. Select [6 DISP. STOPPED TRACKS].
5. Select [ON] or [OFF] as required.
• [OFF]: Tracks made while recording is off are
not shown.
• [ON]: Tracks made while recording is off are
shown. However, since tracks are not recorded,
tracks are erased when the power is turned off or the track is not within the dis-
play area. Also, own ship tracks made while recording is off are erased when-
ever recording is restarted, or the display is zoomed in or out.
6. Close the menu.
Recording interval 1 Recording interval 2
Hold
Own ship
Recording
stopped
[DISP. STOPPED TRACKS]
is ON.
Recording
stopped
Own ship track
is erased.
Own ship
Recording
restarted