Users Manual Part 6

6. PLOTTER OPERATION (C-TYPES)
6-8
10. Select [ON] or [OFF] as required.
• [ON]: Show water temperature on the track.
• [OFF]: Hide water temperature on the track.
11. Close the menu.
Method 2: preset-difference-based color change
According to the setting, there are five colors which are used in a cycle to color the
track. In the example figure below, the preset difference is set to [EV. 0.2] and the tem-
perature ranges from 17.0°C to 18.2°C. The color changes every 0.2°C.
1. Open the menu.
2. Select [MARKS•PLOTTER].
3. Select [TRACK].
4. Select [OWN TRACK SETTINGS].
5. Select [NEXT].
6. Select [TRACK COLOR BY TEMP].
7. Select [EV. 0.2] or [EV. 2.0] as required.
• [EV. 0.2]: changes the color with every temperature increase/decrease of
0.2°C.
• [EV. 2.0]: changes the color with every temperature increase/decrease of
2.0°C.
8. Set the color for the temperature range.
For example, to show water temperatures above 18 degrees centigrade in red col-
or, do the following:
1) Select [RED].
2) Rotate the scrollwheel to set “+18.0”, then press the left button.
3) Set the other colors in a similar manner.
Note 1: The water temperature steps should be in ascending order.
Note 2: Temperatures below the [BLUE] setting appear in white color.
9. Select [TEMP DATA DISPLAY].
10. Select [ON] or [OFF] as required.
• [ON]: Show water temperature on the track.
• [OFF]: Hide water temperature on the track.
11. Close the menu.
Own ship
Yellow
Yellow
Red
Red
Magenta
Green
Blue
17.0°C
17.2°C
17.4°C
17.6°C
17.8°C
18.0°C
18.2°C