Users Manual Part 3

1. OPERATIONAL OVERVIEW
1-87
Note: When a length other than [NORMAL] is selected, set [3 TRAIL GRADA-
TION] to [SINGLE]. If you select [MULTI], the interval between each colored seg-
ment may be difficult to see clearly.
8. Close the menu.
1.37.13 How to set the trail color (C-type only)
The setting for trail coloration depends on the setting for [3 TRAIL GRADATION] and
[4 TRAIL LENGTH], as shown in the following table.
Where [TRAIL LENGTH] is set to [NORMAL]
You can assign one of six colors when [4 TRAIL LENGTH] is set to [NORMAL].
1. Open the menu.
2. Select [1 ECHO].
3. Select [0 NEXT].
4. Select [4 TRAILS]. The [TRAILS] menu appears.
5. Select [4 TRAIL COLOR].
6. Select the required color. The available colors are: [GRN] (green), [BLU] (blue),
[CYA] (cyan), [MAG] (magenta), [WHT] (white) and [YEL] (yellow).
7. Close the menu.
Where [TRAIL LENGTH] is set to other than [NORMAL]
When [4 TRAIL LENGTH] is set to [12H], [24H] or [48H], you can color the trails with
one of two methods: one continuous color, or multicolor.
1. Open the menu.
2. Select [1 ECHO].
3. Select [0 NEXT].
4. Select [4 TRAILS]. The [TRAILS] menu appears.
5. Select [0 NEXT] to show the second page of the menu.
6. Select [6 LONG TRAIL COLOR]. The [LONG TRAIL
COLOR MENU] appears (see figure to the right).
7. Select [3 LONG TRAIL COLORS].
8. Set the colors as desired.
Left-click to move the cursor through the colors, spin
the scrollwheel to change the highlighted color. The
menu shows 12 colors, numbered accordingly from [1]
to [12]. The first segment of the trails is assigned the
color for number [1].
9. Close the menu.
Length Gradation Setting location
NORMAL SINGLE [MAIN]  [2 ECHO]  [0 NEXT]  [4 TRAILS] 
[4 TRAIL COLOR]
MULTI
[12H], [24H], [48H] MULTI
SINGLE [MAIN]  [2 ECHO]  [0 NEXT]  [4 TRAILS] 
[0 NEXT]  [6 LONG TRAIL COLOR]