Users Manual Part 3

1. OPERATIONAL OVERVIEW
1-96
1.40.7 How to change PI line length
You can change the length of the PI lines. This function is only available when [SET
MAXIMUM PI LINES] is set to [1]. If not already displayed, you can show PI lines for
which you wish to change the length by referring to section 1.40.2.
1. Open the menu.
2. For IMO-types, select [3 NAV TOOLS].
For C-types, select [3 CURSOR•EBL•VRM].
3. Select [2 PI LINES]. The [PI LINES] menu appears.
4. Select [6 TRUNC RANGE 1].
5. Select [ON].
6. Spin the scrollwheel to adjust the front PI line length. The available range is 0.000
NM to 24.000 NM. All PI lines beyond this mark will be hidden.
7. Left-click to confirm the setting.
8. Select [7 TRUNC RANGE 2].
9. Select [ON].
10. Spin the scrollwheel to adjust the front PI line length. The available range is 0.000
NM to 24.000 NM. All PI lines beyond this mark will be hidden.
11. To change the length of other PI lines, activate the line you wish to adjust, then
repeat steps 1 through 10.
12. Close the menu.
1.40.8 How to change the PI line color (C-types only)
You can change the PI line color with the following procedure.
1. Open the menu.
2. Select [3 CURSOR•EBL•VRM].
3. Select [2 PI LINES].
4. Select [0 NEXT] to show the second page of the menu.
5. Select [2 PI LINE COLOR].
6. Select the desired color from the menu. The options are: [RED] (red), [GRN]
(green), [BLU] (blue), [YEL] (yellow), [CYA] (cyan), [MAG] (magenta), [WHT]
(white), [ORG] (orange, default).
7. Close the menu.
Heading line PI line
TRUNC RANGE 1 length setting
TRUNC RANGE 1 length setting
TRUNC RANGE 2 length setting
TRUNC RANGE 2 length setting
OS location