Users Manual Part 7

3. ADJUSTMENTS
3-9
0 for both the [START] and [ANGLE] sections. The setting range of [START] is 0° to
359° (default: 000°) and [ANGLE] is 0° to 180° (default: 000°).
Note 1: Turn off a stern blind sector when adjusting the PM gain, to display the echo
from the performance monitor properly.
Note 2: If the PM is active, these menus are NOT available on FAR-2x58 radars.
[HSC]
Select [ON] for HSC only.
Note: This menu is NOT available when the [MODEL] setting is set to [50] (see
"[MODEL]" on page 3-12).
[ANTENNA ROTATION]
This menu is available when [HSC] is set to [ON].
Note 1: When this menu appears in gray, it is not available. The antenna rotation
speed is fixed at 24 rpm.
Note 2: For 42 rpm S-band radars, the High Speed Kit (type: OP03-248, available as
an optional extra) is required.
Select [LO] for 36 rpm, [HI] for 42 rpm. [AUTO] sets the
normal rotation speed to 36 rpm and switches the rota-
tion speed to 42 rpm when the short pulse is selected
(default: [AUTO]).
[ANTENNA SWITCH]
Select [OFF] at [ANTENNA SWITCH] to prevent antenna rotation. For [EXT], set on/
off from an external device (default: [ON]).
[ANT STOPPED]
For qualified technician. [ANT STOPPED] prevents transmission while the antenna is
stopped in STBY (default: [STBY]).
[DUAL RADAR SETTINGS]
When installing two FAR-2xx8 series radars, the im-
age from both radars (main radar and external radar)
may be shown together on one radar display.
Note 1: This function is NOT available between the
FAR-2xx8 radar and other radars.
Note 2: This function is available only for A/B type
radars installed with software version “01.**”.
Note 3: When [COMBINE] is selected, some func-
tion are unavailable. The following table shows the
available menus in the [RADAR INSTALLATION]
menu when [COMBINE] is selected. For menu operations, see the Operator’s manual
(OME-36520). The unavailable menus are displayed in gray.
Image from
external radar
Image from
external radar
Image from main radarImage from main radar